Telephone settings
Answering system settings (handset only)
To delete your outgoing announcement:
1.When the handset is in idle mode, press MENU/SELECT to enter the main menu.
2.Press MENU/SELECT again.
3.Press qCID or DIRp to scroll to >ANS SYS SETUP, then press
MENU/SELECT.
4.Press qCID or DIRp to scroll to >ANNOUNCEMENT, then press
MENU/SELECT, the system announces, “To play, press 2. To record, press 7.”
5.Press 3 to delete your recorded announcement. The system announces “Announcement deleted.”
When your announcement is deleted, the system answers calls with the pre- recorded announcement described on the previous page.
Number of rings
You can set the answering system to answer an incoming call after two, four, or six rings. You can also select toll saver, which is explained below. Unless you change it, the answering system answers an incoming call after four rings.
To set the number of rings on a cordless handset:
1.When the handset is in idle mode, press MENU/SELECT to enter the main menu.
2.Press MENU/SELECT again.
3.Press qCID or DIRp to scroll to >ANS SYS SETUP, then press MENU/SELECT.
4.Press qCID or DIRp to scroll to ># OF RINGS, then press
MENU/SELECT.
5.Press qCID or DIRp to scroll and choose among 2, 4, 6 or
TOLL SAVER.
Toll saver - the answering system answers a call after two rings if you have new messages, and after four rings when there are no new messages. This feature allows you to check for new messages and avoid paying long distance charges when calling from out of your local area.
6.Press MENU/SELECT to confirm your setting. A confirmation tone sounds.
>ANS. SYSTEM
DIRECTORY
>ANS SYS SETUP
PLAY MSGS
># OF RINGS REMOTE CODE
#OF RINGS
2
NOTE: If you subscribe to voicemail services through your telephone service provider, see Answering system and voicemail on page 55.
21