Appendix D
Troubleshooting
| • | Eliminate any background noise. Noise from a |
|
| television, radio or other appliances might cause the |
|
| phone to not dial out properly. If you cannot eliminate |
|
| the background noise, first try muting the cordless |
|
| handset before dialing, or dialing from another room |
|
| with less background noise. |
| • | If the other phones in your home are having the same |
|
| problem, contact your telephone service provider |
|
| (charges might apply). |
|
|
|
My cordless | • | Make sure you plug the power cord securely into the |
handset isn’t |
| telephone base. Plug the power adapter into a different, |
performing |
| working electrical outlet without a wall switch. |
normally. | • | Move the cordless handset closer to the telephone |
| ||
|
| base. You might have moved out of range. |
| • | Reset the telephone base. Unplug the electrical power. |
|
| Wait for 15 seconds then plug it back in. Allow up to |
|
| one minute for the cordless handset and telephone |
|
| base to reset. |
| • | Other electronic products can cause interference to |
|
| your cordless phone. Try installing your phone as far |
|
| away from these types of electronic devices as possible: |
|
| television sets, VCRs, or other cordless telephones. |
The handset registration is unsuccessful.
Follow the steps below to
1.Make sure the handset is out of the charger and shows NOT REGISTERED before you begin registration.
2.Press and hold INTERCOM/HANDSET LOCATOR for about four seconds (until the red IN USE light on the telephone base is on) and then release the button.
3.Place the unregistered handset into the charger.
Refer to the handset registration section on page 67 for details.
The handset | Unplug the battery from the handset and plug it back in |
screen shows | (page 8). The screen should now show NOT REGISTERED |
PRESS HNDST | and you can follow the registration instructions on |
LOC 4 SEC ON | page 67. |
BASE and the |
|
handset is out of |
|
the charger. |
|
70