Lucent Technologies 954 user manual Set for Two or Three Phone Lines, Set Up for a Private Line

Page 13

TELEPHONE FEATURE SETUP

Set for Two or Three Phone Lines

If you’re not using all four phone lines, you need to turn off the line status for the unused line. If you expand to a third or fourth line, turn the line status back on. You cannot turn off line status for Line 1.

1Press G, *, #.

2Press 2for Line 2

— OR —

Press 3for Line 3

— OR —

Press 4for Line 4.

3Press 0to turn off line status

— OR —

Press 1to turn on line status.

4Press T. You’ll hear a confirmation ring.

Set Up for a Private Line

This feature works only if you have three phone lines connected. Line 4 may vary from phone to phone, so you can consider this a private line that other 954 phones cannot access.

NOTE: The phone number for Line 1 must be the same on all phones for the intercom and paging features to work.

1Press G, *, #.

2Enter a different line number (05–08) for each private line.

3Press and release H. You’ll hear a confirmation ring.

Change BATTERY Display

When battery power is low, the screen flashes BATTERY. Replace the batteries promptly to prevent memory loss (see the INSTALLATION section in this manual). You can set the phone so the screen won’t display the BATTERY message.

1Press G, *, #, *.

2Press and release 0to prevent BATTERY display

— OR —

Press and release 1to enable BATTERY display.

3Press and release C. You’ll hear a confirmation ring.

11

Lucent 0954 book.L1

11

5/7/98, 10:35 AM

Image 13

Contents User’s Manual for Four-Line Intercom/ Speakerphone Philips Consumer Communications L.P. All rights reserved Contents Lucent 0954 book.L1 98, 1034 AM Before YOU Begin Table/Desk Installation InstallationInstall 3 AAA batteries Connect the telephone line cords to the telephoneConnect the handset cord Connect the power adapterCheck for dial tone Reverse the handset tab Wall InstallationConnect the power adapter to the telephone Mount the phone on the wall Standard Electrical Outlet Convenience Port Set Dial Mode Telephone Feature SetupAssign Intercom Number Set the ClockChange Battery Display Set Up for a Private LineSet for Two or Three Phone Lines Operation Call Privacy Making a CallLine-In-Use Lights Handset/Speakerphone Volume Control VolumeRinger Volume Turning Ringer OffRedial Switch Between LinesAuto Redial HoldFlash MuteTemporary Tone Dialing Conference CallsTransfer a Call Do Not DisturbTransferring an Announced Call Transferring an Unannounced CallTimer Telephone Memory Directory Card Storing a Temporary Tone Signal in a Memory NumberStoring Numbers in Memory Storing a Pause in a Memory NumberIntercom Operation Making an Intercom Call or Basic Intercom OperationsAnswering an Intercom Call or Ending an Intercom Call orAnswering an Allpage Paging All PhonesMaking an Intercom Conference Call Room MonitorCase of Difficulty Tone Signals Do Not Activate a Remote Device Intercom Paging Signal Not ReceivedOperation During a Power Failure Cannot Use DND, TIMER, Allpage or SETExpanding the 954 System Setting Up a Fourth Line for Each Station Setup ChecklistCentrex Operation Enabling/Disabling Attendant StationAnswering a Delayed Ring Setting Ring Delay DurationAttendant Operation Picking Up Another Station’s Line Page Page