Lucent Technologies 954 user manual Making a Call, Call Privacy, Line-In-Use Lights

Page 15

OPERATION

NOTE: When you make a call, the phone selects the first available line. When you answer a call, the phone automatically selects the ringing line. If you have a private line, the phone automatically selects that line.

Making a Call

Handset

To make a call, lift the handset. You can dial your call manually or use the memory dialing feature.

To answer a call, lift the handset. Replace the handset to end the call.

To override automatic line selection, press and release a LINE button (this activates the speakerphone), then lift the handset.

Speakerphone

To make a call, press and release K. The SPEAKER light goes on. Wait for a dial tone, then dial the call manually or by using memory dialing.

To answer a call, press K. Press Kagain to end the call.

To switch from handset to speakerphone, press K, then replace

the handset.

To switch from speakerphone to handset, lift the handset.

To override automatic line selection, press and release a LINE button (this activates the speakerphone).

Call Privacy

To ensure call privacy, the phone allows only one set at a time to use a line.

Canceling Call Privacy

During the call, press the line button for the call. You’ll hear a short ringing tone. Others can now join the call.

Restoring Call Privacy

Press the line button again during the call. You’ll hear a double-ring. The other phones will be dropped from the call.

NOTE: Call privacy is automatically restored when you end the call.

Line-In-Use Lights

Whenever a line is in use, the light flashes slowly on the phone using that line. On the other phones, the light stays on steadily to indicate someone else is using the line.

13

Lucent 0954 book.L1

13

5/7/98, 10:35 AM

Page 14 Page 16
Image 15
Page 14 Page 16
Contents User’s Manual for Four-Line Intercom/ Speakerphone Philips Consumer Communications L.P. All rights reserved Contents Lucent 0954 book.L1 98, 1034 AM Before YOU Begin Connect the telephone line cords to the telephone InstallationTable/Desk Installation Install 3 AAA batteriesConnect the power adapter Connect the handset cordCheck for dial tone Reverse the handset tab Wall InstallationConnect the power adapter to the telephone Mount the phone on the wall Standard Electrical Outlet Convenience Port Set the Clock Telephone Feature SetupSet Dial Mode Assign Intercom NumberSet Up for a Private Line Change Battery DisplaySet for Two or Three Phone Lines Operation Making a Call Call PrivacyLine-In-Use Lights Turning Ringer Off VolumeHandset/Speakerphone Volume Control Ringer VolumeHold Switch Between LinesRedial Auto RedialConference Calls MuteFlash Temporary Tone DialingTransferring an Unannounced Call Do Not DisturbTransfer a Call Transferring an Announced CallTimer Telephone Memory Storing a Pause in a Memory Number Storing a Temporary Tone Signal in a Memory NumberDirectory Card Storing Numbers in MemoryIntercom Operation Ending an Intercom Call or Basic Intercom OperationsMaking an Intercom Call or Answering an Intercom Call orRoom Monitor Paging All PhonesAnswering an Allpage Making an Intercom Conference CallCase of Difficulty Cannot Use DND, TIMER, Allpage or SET Intercom Paging Signal Not ReceivedTone Signals Do Not Activate a Remote Device Operation During a Power FailureExpanding the 954 System Enabling/Disabling Attendant Station Setup ChecklistSetting Up a Fourth Line for Each Station Centrex OperationSetting Ring Delay Duration Answering a Delayed RingAttendant Operation Picking Up Another Station’s Line Page Page
Top Page Image Contents