Lucent Technologies 954 user manual Case of Difficulty

Page 26

IN CASE OF DIFFICULTY

If this telephone does not work properly, try the following suggestions. If you’re still having problems, call 1 800 PCC–9125.

No Dial Tone

Make sure all plugs are connected properly. Inspect the line cord connections at the modular jack and at the telephone. Also inspect the coiled handset cord connection at both ends.

Check to make sure the phone is not on hold.

Call Cannot Be Dialed or is Dialed Slowly

This product comes set to touch tone mode. If you have dial pulse (rotary) dialing service, you cannot dial numbers with the phone set to touch tone. See the TELEPHONE FEATURE SETUP section of this manual to set the dial mode to PULSE.

Interference on Intercom or Phone Calls

This phone uses sensitive circuitry that may pick up interference in environments with excessive electrical noise. To minimize interference, keep electrical noise sources away from telephone wiring and sets.

Telephone Lights Flutter Continuously

Power may have been interrupted.

If AC power is controlled by a wall switch, make sure the switch is turned on.

Check the power cords on all system phones, and check the fuse or circuit breaker that serves the phones.

Check the telephone jack by disconnecting the 954 and connecting another non-system telephone.

Check that all line assignments are correct, and that all 954 phones are on the line designated as Line 1.

Difficulty Storing Numbers in Memory

Make sure you are pressing the correct sequence of buttons for storing one-touch and two-touch numbers.

Make sure the telephone is idle while you are storing numbers. If you lift the handset or press Kwhile storing numbers, the number will be entered incorrectly.

24

Lucent 0954 book.L1

24

5/7/98, 10:36 AM

Image 26
Contents User’s Manual for Four-Line Intercom/ Speakerphone Philips Consumer Communications L.P. All rights reserved Contents Lucent 0954 book.L1 98, 1034 AM Before YOU Begin Install 3 AAA batteries InstallationTable/Desk Installation Connect the telephone line cords to the telephoneCheck for dial tone Connect the power adapterConnect the handset cord Wall Installation Reverse the handset tabConnect the power adapter to the telephone Mount the phone on the wall Standard Electrical Outlet Convenience Port Assign Intercom Number Telephone Feature SetupSet Dial Mode Set the ClockSet for Two or Three Phone Lines Set Up for a Private LineChange Battery Display Operation Line-In-Use Lights Making a CallCall Privacy Ringer Volume VolumeHandset/Speakerphone Volume Control Turning Ringer OffAuto Redial Switch Between LinesRedial HoldTemporary Tone Dialing MuteFlash Conference CallsTransferring an Announced Call Do Not DisturbTransfer a Call Transferring an Unannounced CallTimer Telephone Memory Storing Numbers in Memory Storing a Temporary Tone Signal in a Memory NumberDirectory Card Storing a Pause in a Memory NumberIntercom Operation Answering an Intercom Call or Basic Intercom OperationsMaking an Intercom Call or Ending an Intercom Call orMaking an Intercom Conference Call Paging All PhonesAnswering an Allpage Room MonitorCase of Difficulty Operation During a Power Failure Intercom Paging Signal Not ReceivedTone Signals Do Not Activate a Remote Device Cannot Use DND, TIMER, Allpage or SETExpanding the 954 System Centrex Operation Setup ChecklistSetting Up a Fourth Line for Each Station Enabling/Disabling Attendant StationAttendant Operation Setting Ring Delay DurationAnswering a Delayed Ring Picking Up Another Station’s Line Page Page