Lucent Technologies 954 user manual Handset/Speakerphone Volume Control, Ringer Volume

Page 16

OPERATION

Volume

Handset/Speakerphone Volume Control

When you are on a call, press +to increase handset or speakerphone volume. Press -to decrease volume.

Ringer Volume

You can adjust the ringer volume while the phone is ringing. While the line is ringing, press +or -to reach the desired level. If more than one line is ringing at the same time, both will be adjusted.

This phone has four ringer volume levels. Each time you adjust the ringer, you will hear a sample indicating the volume level. To adjust ringer volume when the line is not ringing, follow the steps below.

1Press and release C.

2Choose the line for ringer adjustment. Press and release 1for Line 1

— OR —

Press and release 1for Line 2

— OR —

Press and release 3for Line 3

— OR —

Press and release 4for Line 4.

3Press +to increase volume

— OR —

Press -to decrease volume.

Turning Ringer Off

1Press and release C.

2Choose the line for ringer adjustment. Press and release 1for Line 1

— OR —

Press and release 2for Line 2

— OR —

Press and release 3for Line 3

— OR —

Press and release 4for Line 4.

3Press -until you no longer hear a tone.

14

Lucent 0954 book.L1

14

5/7/98, 10:35 AM

Image 16
Contents User’s Manual for Four-Line Intercom/ Speakerphone Philips Consumer Communications L.P. All rights reserved Contents Lucent 0954 book.L1 98, 1034 AM Before YOU Begin Installation Table/Desk InstallationInstall 3 AAA batteries Connect the telephone line cords to the telephoneConnect the handset cord Connect the power adapterCheck for dial tone Wall Installation Reverse the handset tabConnect the power adapter to the telephone Mount the phone on the wall Standard Electrical Outlet Convenience Port Telephone Feature Setup Set Dial ModeAssign Intercom Number Set the ClockChange Battery Display Set Up for a Private LineSet for Two or Three Phone Lines Operation Call Privacy Making a CallLine-In-Use Lights Volume Handset/Speakerphone Volume ControlRinger Volume Turning Ringer OffSwitch Between Lines RedialAuto Redial HoldMute FlashTemporary Tone Dialing Conference CallsDo Not Disturb Transfer a CallTransferring an Announced Call Transferring an Unannounced CallTimer Telephone Memory Storing a Temporary Tone Signal in a Memory Number Directory CardStoring Numbers in Memory Storing a Pause in a Memory NumberIntercom Operation Basic Intercom Operations Making an Intercom Call orAnswering an Intercom Call or Ending an Intercom Call orPaging All Phones Answering an AllpageMaking an Intercom Conference Call Room MonitorCase of Difficulty Intercom Paging Signal Not Received Tone Signals Do Not Activate a Remote DeviceOperation During a Power Failure Cannot Use DND, TIMER, Allpage or SETExpanding the 954 System Setup Checklist Setting Up a Fourth Line for Each StationCentrex Operation Enabling/Disabling Attendant StationAnswering a Delayed Ring Setting Ring Delay DurationAttendant Operation Picking Up Another Station’s Line Page Page