Lucent Technologies 954 user manual Connect the telephone line cords to the telephone

Page 9

INSTALLATION

4Connect the telephone line cords to the telephone.

• Four One-Line Jacks

Modular

Telephone Jacks

Lines 3 and 4

Modular

Telephone Jacks

Lines 1 and 2

Standard

Electrical

Outlet

Telephone Jacks

Telephone	Power Cord
Line Cords

•Two Two-Line Jacks

Modular

Telephone Jack

Lines 3 and 4

Modular

Telephone Jack

Lines 1 and 2

Telephone Jacks

Standard

Electrical

Outlet

Telephone	Power Cord
Line Cords

5Connect the power adapter to the telephone.

Use only the power adapter provided with this product. To obtain a replacement, call 1 800 PCC–9125.

Plug one end of the power adapter into the jack labeled ADAPTER on the back of the phone.

7

Lucent 0954 book.L1

7

5/7/98, 10:35 AM

Image 9

Contents User’s Manual for Four-Line Intercom/ Speakerphone Philips Consumer Communications L.P. All rights reserved Contents Lucent 0954 book.L1 98, 1034 AM Before YOU Begin Table/Desk Installation InstallationInstall 3 AAA batteries Connect the telephone line cords to the telephoneConnect the power adapter Connect the handset cordCheck for dial tone Reverse the handset tab Wall InstallationConnect the power adapter to the telephone Mount the phone on the wall Standard Electrical Outlet Convenience Port Set Dial Mode Telephone Feature SetupAssign Intercom Number Set the ClockSet Up for a Private Line Change Battery DisplaySet for Two or Three Phone Lines Operation Making a Call Call PrivacyLine-In-Use Lights Handset/Speakerphone Volume Control VolumeRinger Volume Turning Ringer OffRedial Switch Between LinesAuto Redial HoldFlash MuteTemporary Tone Dialing Conference CallsTransfer a Call Do Not DisturbTransferring an Announced Call Transferring an Unannounced CallTimer Telephone Memory Directory Card Storing a Temporary Tone Signal in a Memory NumberStoring Numbers in Memory Storing a Pause in a Memory NumberIntercom Operation Making an Intercom Call or Basic Intercom OperationsAnswering an Intercom Call or Ending an Intercom Call orAnswering an Allpage Paging All PhonesMaking an Intercom Conference Call Room MonitorCase of Difficulty Tone Signals Do Not Activate a Remote Device Intercom Paging Signal Not ReceivedOperation During a Power Failure Cannot Use DND, TIMER, Allpage or SETExpanding the 954 System Setting Up a Fourth Line for Each Station Setup ChecklistCentrex Operation Enabling/Disabling Attendant StationSetting Ring Delay Duration Answering a Delayed RingAttendant Operation Picking Up Another Station’s Line Page Page