Lucent Technologies 954 user manual Contents

Page 3

BEFORE YOU BEGIN	3
INSTALLATION	4
Table/Desk Installation	4
Wall Installation	6
TELEPHONE FEATURE SETUP	10
Assign Intercom Number	10
Set the Clock	10
Set Dial Mode	10
Set for Two or Three Phone Lines	11
Set Up for a Private Line	11
Change BATTERY Display	11
OPERATION	12
Making a Call	13
Call Privacy	13
Line-In-Use Lights	13
Volume	14
Redial	15
Auto Redial	15
Hold	15
Switch Between Lines	15
Mute	16
Flash	16
Temporary Tone Dialing	16
Conference Calls	16
Do Not Disturb	17
Transfer a Call	17
Timer	18
TELEPHONE MEMORY	19
Directory Card	20
Storing Numbers in Memory	20
Storing a Pause in a
Memory Number	20
Storing a Temporary Tone Signal
in a Memory Number	20
Storing Flash in a Memory Number ....	20
Erasing Memory Numbers	20

CONTENTS
INTERCOM OPERATION	21
Basic Intercom Operations	22
Making an Intercom Call or Page	22
Answering an Intercom Call or Page ...	22
Ending an Intercom Call or Page	22
Paging All Phones	23
Answering an ALLPAGE	23
Making an Intercom
Conference Call	23
Room Monitor	23
Checking Your Station Number	23
IN CASE OF DIFFICULTY	24
EXPANDING THE 954 SYSTEM	26
CENTREX OPERATION	27
Setup Checklist	27
Setting Up a Fourth Line
for Each Station	27
Enabling/Disabling Attendant Station ..	27
Attendant Operation	28
Setting Ring Delay Duration	28
Answering a Delayed Ring	28
Picking Up Another Station’s Line	29

1

Lucent 0954 book.L1

1

5/7/98, 10:34 AM

Image 3

Contents User’s Manual for Four-Line Intercom/ Speakerphone Philips Consumer Communications L.P. All rights reserved Contents Lucent 0954 book.L1 98, 1034 AM Before YOU Begin Connect the telephone line cords to the telephone InstallationTable/Desk Installation Install 3 AAA batteriesConnect the power adapter Connect the handset cordCheck for dial tone Reverse the handset tab Wall InstallationConnect the power adapter to the telephone Mount the phone on the wall Standard Electrical Outlet Convenience Port Set the Clock Telephone Feature SetupSet Dial Mode Assign Intercom NumberSet Up for a Private Line Change Battery DisplaySet for Two or Three Phone Lines Operation Making a Call Call PrivacyLine-In-Use Lights Turning Ringer Off VolumeHandset/Speakerphone Volume Control Ringer VolumeHold Switch Between LinesRedial Auto RedialConference Calls MuteFlash Temporary Tone DialingTransferring an Unannounced Call Do Not DisturbTransfer a Call Transferring an Announced CallTimer Telephone Memory Storing a Pause in a Memory Number Storing a Temporary Tone Signal in a Memory NumberDirectory Card Storing Numbers in MemoryIntercom Operation Ending an Intercom Call or Basic Intercom OperationsMaking an Intercom Call or Answering an Intercom Call orRoom Monitor Paging All PhonesAnswering an Allpage Making an Intercom Conference CallCase of Difficulty Cannot Use DND, TIMER, Allpage or SET Intercom Paging Signal Not ReceivedTone Signals Do Not Activate a Remote Device Operation During a Power FailureExpanding the 954 System Enabling/Disabling Attendant Station Setup ChecklistSetting Up a Fourth Line for Each Station Centrex OperationSetting Ring Delay Duration Answering a Delayed RingAttendant Operation Picking Up Another Station’s Line Page Page