Lucent Technologies 954 Centrex Operation, Setup Checklist, Enabling/Disabling Attendant Station

Page 29

CENTREX OPERATION

Setup Checklist

Before expanding your system or installing for Centrex, review the installation checklist. If you have Centrex, contact your local telephone company for further information about Centrex service.

The phone number for Line 1 must be the same on all phones in order for the Intercom and Paging features to work.

Determine the number of phones that will be on the system.

Identify the phone that will be the attendant phone.

Identify the private line for the attendant phone. The attendant phone must have its own private line. This line is not shared with any other phone.

Follow the regular installation instructions in this manual.

Enable the attendant phone.

Store the Centrex pickup codes and the seven-digit phone numbers into memory locations. See TELEPHONE MEMORY in this manual.

Setting Up a Fourth Line for Each Station

1Press G*#.

2Enter the line number (05–08) you want as your fourth line. For example, if stations 16, 19, and 20 share Line 5, those stations would enter 05.

3Press and release H. You’ll hear a confirmation ring.

Repeat Steps 1–3 for each station on the system that will have a private line.

Enabling/Disabling Attendant Station

This feature lets you have an attendant phone on the system. An attendant phone can pick up other Centrex lines through Centrex switching. Identify which station you want as the attendant. The attendant phone should also have a private line.

1Make sure the phone is not in use.

2Press G*#*.

3Press 1to enable

— OR —

Press 0to disable.

4Press M. You’ll hear a confirmation ring.

27

Lucent 0954 book.L1

27

5/7/98, 10:36 AM

Image 29
Contents User’s Manual for Four-Line Intercom/ Speakerphone Philips Consumer Communications L.P. All rights reserved Contents Lucent 0954 book.L1 98, 1034 AM Before YOU Begin Table/Desk Installation InstallationInstall 3 AAA batteries Connect the telephone line cords to the telephoneCheck for dial tone Connect the power adapterConnect the handset cord Reverse the handset tab Wall InstallationConnect the power adapter to the telephone Mount the phone on the wall Standard Electrical Outlet Convenience Port Set Dial Mode Telephone Feature SetupAssign Intercom Number Set the ClockSet for Two or Three Phone Lines Set Up for a Private LineChange Battery Display Operation Line-In-Use Lights Making a CallCall Privacy Handset/Speakerphone Volume Control VolumeRinger Volume Turning Ringer OffRedial Switch Between LinesAuto Redial HoldFlash MuteTemporary Tone Dialing Conference CallsTransfer a Call Do Not DisturbTransferring an Announced Call Transferring an Unannounced CallTimer Telephone Memory Directory Card Storing a Temporary Tone Signal in a Memory NumberStoring Numbers in Memory Storing a Pause in a Memory NumberIntercom Operation Making an Intercom Call or Basic Intercom OperationsAnswering an Intercom Call or Ending an Intercom Call orAnswering an Allpage Paging All PhonesMaking an Intercom Conference Call Room MonitorCase of Difficulty Tone Signals Do Not Activate a Remote Device Intercom Paging Signal Not ReceivedOperation During a Power Failure Cannot Use DND, TIMER, Allpage or SETExpanding the 954 System Setting Up a Fourth Line for Each Station Setup ChecklistCentrex Operation Enabling/Disabling Attendant StationAttendant Operation Setting Ring Delay DurationAnswering a Delayed Ring Picking Up Another Station’s Line Page Page