Lucent Technologies 954 user manual Telephone Does Not Ring, Intercom Paging Signal Not Received

Page 27

IN CASE OF DIFFICULTY

Telephone Does Not Ring

•Make sure the Do Not Disturb (DND) feature is not activated.

•Make sure ringers are turned on.

•If there are several non-system phones on the line that doesn’t ring, disconnect some of them. Having too many phones connected can also result in low ringer volume for non-system telephones.

•If the INTERCOM light flashes but you don’t hear a paging signal, make sure the Do Not Disturb feature is not activated.

Intercom Paging Signal Not Received

Make sure you have programmed your intercom station number correctly.

Cannot Join a Conversation in Progress

The privacy feature prevents another set on the system from interrupting a conversation. Make sure you press the line button to release privacy.

Line Lights Remain On

If the line lights remain on even if no line is connected, make sure the system is programmed for that line to be absent. See “Set for Two or Three Phone Lines” in the TELEPHONE FEATURE SETUP section of this manual.

Tone Signals Do Not Activate a Remote Device

•Tone signaling does not work during conference calls.

•The phone generates tones of fixed duration, which may not be long enough to activate some devices such as answering machines.

Answering Machine Does Not Answer

Telephone answering machines must connect directly to the line. If you have a two-line answering machine, it must connect to a two-line jack, or to two jacks on different lines.

Operation During a Power Failure

This phone does not operate during a power failure.

Cannot Use DND, TIMER, ALLPAGE or SET

Make sure lis not turned on. If LOWER is displayed, press lto turn it off.

25

Lucent 0954 book.L1

25

5/7/98, 10:36 AM

Page 26 Page 28
Image 27
Page 26 Page 28
Contents User’s Manual for Four-Line Intercom/ Speakerphone Philips Consumer Communications L.P. All rights reserved Contents Lucent 0954 book.L1 98, 1034 AM Before YOU Begin Connect the telephone line cords to the telephone InstallationTable/Desk Installation Install 3 AAA batteriesConnect the power adapter Connect the handset cordCheck for dial tone Reverse the handset tab Wall InstallationConnect the power adapter to the telephone Mount the phone on the wall Standard Electrical Outlet Convenience Port Set the Clock Telephone Feature SetupSet Dial Mode Assign Intercom NumberSet Up for a Private Line Change Battery DisplaySet for Two or Three Phone Lines Operation Making a Call Call PrivacyLine-In-Use Lights Turning Ringer Off VolumeHandset/Speakerphone Volume Control Ringer VolumeHold Switch Between LinesRedial Auto RedialConference Calls MuteFlash Temporary Tone DialingTransferring an Unannounced Call Do Not DisturbTransfer a Call Transferring an Announced CallTimer Telephone Memory Storing a Pause in a Memory Number Storing a Temporary Tone Signal in a Memory NumberDirectory Card Storing Numbers in MemoryIntercom Operation Ending an Intercom Call or Basic Intercom OperationsMaking an Intercom Call or Answering an Intercom Call orRoom Monitor Paging All PhonesAnswering an Allpage Making an Intercom Conference CallCase of Difficulty Cannot Use DND, TIMER, Allpage or SET Intercom Paging Signal Not ReceivedTone Signals Do Not Activate a Remote Device Operation During a Power FailureExpanding the 954 System Enabling/Disabling Attendant Station Setup ChecklistSetting Up a Fourth Line for Each Station Centrex OperationSetting Ring Delay Duration Answering a Delayed RingAttendant Operation Picking Up Another Station’s Line Page Page
Top Page Image Contents