Lucent Technologies 954 user manual Mute, Flash, Temporary Tone Dialing, Conference Calls

Page 18

OPERATION

Mute

This feature lets you mute the telephone so that you can hear the other party, but the other party can’t hear you.

To activate this feature, press and release M. The MUTE light goes on.

To return to the conversation, press and release Magain.

NOTE: Switching from handset to speakerphone or from speakerphone to handset, changing lines, and putting a call on hold also cancel Mute.

Flash

Use Finstead of the switchhook to activate telephone company subscriber services such as Call Waiting or Three-Way Calling.

Temporary Tone Dialing

If you have dial pulse (rotary) service, you can change from dial pulse to touch tone dialing during a call by pressing *. This is useful if you need to send touch tone signals for access to telephone banking or long-distance services.

1Dial the number.

2Press and release *. Buttons pressed after this send touch tone signals.

3After you hang up, the phone automatically returns to rotary service.

Conference Calls

This feature lets you set up a three-party call by using two lines at the same time. You can also join an intercom call with a call on an outside line.

1Make or answer a call.

2Press and release H.

3Call someone on another line.

4When this call is answered, press C. The three-party conference begins immediately.

5To end a conference call, hang up. All parties will disconnect.

To talk privately with one party:

1Press Hto place both lines on hold.

2Press a LINE button to talk privately with the person on that line.

3Press Cto resume conference call.

16

Lucent 0954 book.L1

16

5/7/98, 10:35 AM

Image 18
Contents User’s Manual for Four-Line Intercom/ Speakerphone Philips Consumer Communications L.P. All rights reserved Contents Lucent 0954 book.L1 98, 1034 AM Before YOU Begin Install 3 AAA batteries InstallationTable/Desk Installation Connect the telephone line cords to the telephoneConnect the power adapter Connect the handset cordCheck for dial tone Wall Installation Reverse the handset tabConnect the power adapter to the telephone Mount the phone on the wall Standard Electrical Outlet Convenience Port Assign Intercom Number Telephone Feature SetupSet Dial Mode Set the ClockSet Up for a Private Line Change Battery DisplaySet for Two or Three Phone Lines Operation Making a Call Call PrivacyLine-In-Use Lights Ringer Volume VolumeHandset/Speakerphone Volume Control Turning Ringer OffAuto Redial Switch Between LinesRedial HoldTemporary Tone Dialing MuteFlash Conference CallsTransferring an Announced Call Do Not DisturbTransfer a Call Transferring an Unannounced CallTimer Telephone Memory Storing Numbers in Memory Storing a Temporary Tone Signal in a Memory NumberDirectory Card Storing a Pause in a Memory NumberIntercom Operation Answering an Intercom Call or Basic Intercom OperationsMaking an Intercom Call or Ending an Intercom Call orMaking an Intercom Conference Call Paging All PhonesAnswering an Allpage Room MonitorCase of Difficulty Operation During a Power Failure Intercom Paging Signal Not ReceivedTone Signals Do Not Activate a Remote Device Cannot Use DND, TIMER, Allpage or SETExpanding the 954 System Centrex Operation Setup ChecklistSetting Up a Fourth Line for Each Station Enabling/Disabling Attendant StationSetting Ring Delay Duration Answering a Delayed RingAttendant Operation Picking Up Another Station’s Line Page Page