Lucent Technologies 954 Do Not Disturb, Transfer a Call, Transferring an Announced Call

Page 19

OPERATION

To drop one line:

Press the LINE button of the party you want to keep. The other line will be dropped.

NOTE: Occasionally, the far-end parties on a conference call might not hear one another.

Do Not Disturb

Use this feature to prevent interruptions during a call. When you activate this feature you will not hear paging tones, voice paging, or incoming call rings. Instead, the LINE light flashes and the INTERCOM light goes on to signal a call or page. If you receive an intercom call, the INTERCOM light flashes, and the intercom number calling you appears on the display.

1Press dto prevent interruptions.

2Press dagain to resume normal call alerts.

Transfer a Call

You can transfer a call you answer to any other 954 phone. Once you transfer a call, it can be picked up at any other 954 phone, not just at the intercom number you called. Transfer calls fall into two categories: announced and unannounced. Announced calls let you alert the other person verbally that they have a transferred call. Unannounced calls alert the other person by ringing.

Your phone reminds you every 30 seconds when a transferred call has not been answered.

Transferring an Announced Call

1Press por I.

2Enter the intercom number where you’re transferring the call.

3Begin speaking to alert the other person there’s a call.

To answer a transferred announced call, press the LINE button of the call.

Transferring an Unannounced Call

1Press T.

2Enter the intercom number where you’re transferring the call.

3Hang up.

To answer a transferred unannounced call, pick up the handset or press the LINE button of the call to use the speakerphone.

17

Lucent 0954 book.L1

17

5/7/98, 10:35 AM

Page 18 Page 20
Image 19
Page 18 Page 20
Contents User’s Manual for Four-Line Intercom/ Speakerphone Philips Consumer Communications L.P. All rights reserved Contents Lucent 0954 book.L1 98, 1034 AM Before YOU Begin Connect the telephone line cords to the telephone InstallationTable/Desk Installation Install 3 AAA batteriesConnect the handset cord Connect the power adapterCheck for dial tone Reverse the handset tab Wall InstallationConnect the power adapter to the telephone Mount the phone on the wall Standard Electrical Outlet Convenience Port Set the Clock Telephone Feature SetupSet Dial Mode Assign Intercom NumberChange Battery Display Set Up for a Private LineSet for Two or Three Phone Lines Operation Call Privacy Making a CallLine-In-Use Lights Turning Ringer Off VolumeHandset/Speakerphone Volume Control Ringer VolumeHold Switch Between LinesRedial Auto RedialConference Calls MuteFlash Temporary Tone DialingTransferring an Unannounced Call Do Not DisturbTransfer a Call Transferring an Announced CallTimer Telephone Memory Storing a Pause in a Memory Number Storing a Temporary Tone Signal in a Memory NumberDirectory Card Storing Numbers in MemoryIntercom Operation Ending an Intercom Call or Basic Intercom OperationsMaking an Intercom Call or Answering an Intercom Call orRoom Monitor Paging All PhonesAnswering an Allpage Making an Intercom Conference CallCase of Difficulty Cannot Use DND, TIMER, Allpage or SET Intercom Paging Signal Not ReceivedTone Signals Do Not Activate a Remote Device Operation During a Power FailureExpanding the 954 System Enabling/Disabling Attendant Station Setup ChecklistSetting Up a Fourth Line for Each Station Centrex OperationAnswering a Delayed Ring Setting Ring Delay DurationAttendant Operation Picking Up Another Station’s Line Page Page
Top Page Image Contents