Lucent Technologies 954 user manual Basic Intercom Operations, Making an Intercom Call or

Page 24

INTERCOM OPERATION

This intercom features both a single-phone page and a system-wide page.

Asingle-phone page alerts only one phone; a system-wide page alerts all phones. Any phone with the Do Not Disturb (DND) feature activated will not receive a page.

An intercom call or single-phone page automatically activates the speakerphone on the receiving phone. You can deactivate the speakerphone by lifting the handset.

Use the first 12 memory buttons to make intercom and page calls. When using the intercom, these buttons are intercom stations 11 through 22.

Basic Intercom Operations

INTERCOM Any two stations connected to Line 1 can ring each other.

PAGE Lets you “announce” over the speaker of the phone you’re calling. The person you’ve called can respond just by talking.

ALLPAGE Lets you “announce” to all 954 phones in the system at the same time.

CONF Lets you connect another intercom call with an outside line.

TRNSFR Lets you receive an incoming call and redirect it to any 954 phone on the system.

Making an Intercom Call or Page

1Lift the handset and press Ior p. You’ll hear a tone.

2Press the memory button for the station you’re paging

— OR —

Use the keypad to enter the station number.

NOTE: When you direct an intercom call to one station, any station in the system can answer the call.

Answering an Intercom Call or Page

For an intercom call, press Kor Ior lift the handset.

For a page, begin talking (the speaker is activated) or lift the handset.

Ending an Intercom Call or Page

Press K.

22

Lucent 0954 book.L1

22

5/7/98, 10:36 AM

Image 24
Contents User’s Manual for Four-Line Intercom/ Speakerphone Philips Consumer Communications L.P. All rights reserved Contents Lucent 0954 book.L1 98, 1034 AM Before YOU Begin Installation Table/Desk InstallationInstall 3 AAA batteries Connect the telephone line cords to the telephoneConnect the power adapter Connect the handset cordCheck for dial tone Wall Installation Reverse the handset tabConnect the power adapter to the telephone Mount the phone on the wall Standard Electrical Outlet Convenience Port Telephone Feature Setup Set Dial ModeAssign Intercom Number Set the ClockSet Up for a Private Line Change Battery DisplaySet for Two or Three Phone Lines Operation Making a Call Call PrivacyLine-In-Use Lights Volume Handset/Speakerphone Volume ControlRinger Volume Turning Ringer OffSwitch Between Lines RedialAuto Redial HoldMute FlashTemporary Tone Dialing Conference CallsDo Not Disturb Transfer a CallTransferring an Announced Call Transferring an Unannounced CallTimer Telephone Memory Storing a Temporary Tone Signal in a Memory Number Directory CardStoring Numbers in Memory Storing a Pause in a Memory NumberIntercom Operation Basic Intercom Operations Making an Intercom Call orAnswering an Intercom Call or Ending an Intercom Call orPaging All Phones Answering an AllpageMaking an Intercom Conference Call Room MonitorCase of Difficulty Intercom Paging Signal Not Received Tone Signals Do Not Activate a Remote DeviceOperation During a Power Failure Cannot Use DND, TIMER, Allpage or SETExpanding the 954 System Setup Checklist Setting Up a Fourth Line for Each StationCentrex Operation Enabling/Disabling Attendant StationSetting Ring Delay Duration Answering a Delayed RingAttendant Operation Picking Up Another Station’s Line Page Page