Lucent Technologies 954 user manual Paging All Phones, Answering an Allpage, Room Monitor

Page 25

INTERCOM OPERATION

Paging All Phones

1Press and release aor p.

2Press and release *.

3Speak toward the telephone.

4Press and release Kto disconnect.

Answering an ALLPAGE

1Press aor p.

2Use the already activated speakerphone, or lift the handset.

3To end, press and release Kor hang up.

Making an Intercom Conference Call

1Make or answer a call.

2Press and release Iand enter the station number.

3After the third party answers, press and release C.

4To end an intercom conference call, hang up.

NOTE: You cannot put an intercom conference call on hold.

Room Monitor

You can activate the speaker of another phone to monitor sounds in that room.

1Press and release p.

2Enter the station number of the telephone to be monitored.

3Press and release Mif you don’t want sounds on your end to be heard.

4To end monitoring, press and release K.

Checking Your Station Number

1Press and release I.

2Use the dial pad to enter a station number (11 to 22).

3Press Kto hang up.

4Repeat Steps 1–3 until the intercom light goes off. The last number entered is your station number.

NOTE: If the intercom light stays on even after you enter numbers 11 through 22, your phone does not have a station number. See “Assign Intercom Number” in the TELEPHONE FEATURE SETUP section for assigning intercom station numbers.

23

Lucent 0954 book.L1

23

5/7/98, 10:36 AM

Image 25

Contents User’s Manual for Four-Line Intercom/ Speakerphone Philips Consumer Communications L.P. All rights reserved Contents Lucent 0954 book.L1 98, 1034 AM Before YOU Begin Table/Desk Installation InstallationInstall 3 AAA batteries Connect the telephone line cords to the telephoneConnect the handset cord Connect the power adapterCheck for dial tone Reverse the handset tab Wall InstallationConnect the power adapter to the telephone Mount the phone on the wall Standard Electrical Outlet Convenience Port Set Dial Mode Telephone Feature SetupAssign Intercom Number Set the ClockChange Battery Display Set Up for a Private LineSet for Two or Three Phone Lines Operation Call Privacy Making a CallLine-In-Use Lights Handset/Speakerphone Volume Control VolumeRinger Volume Turning Ringer OffRedial Switch Between LinesAuto Redial HoldFlash MuteTemporary Tone Dialing Conference CallsTransfer a Call Do Not DisturbTransferring an Announced Call Transferring an Unannounced CallTimer Telephone Memory Directory Card Storing a Temporary Tone Signal in a Memory NumberStoring Numbers in Memory Storing a Pause in a Memory NumberIntercom Operation Making an Intercom Call or Basic Intercom OperationsAnswering an Intercom Call or Ending an Intercom Call orAnswering an Allpage Paging All PhonesMaking an Intercom Conference Call Room MonitorCase of Difficulty Tone Signals Do Not Activate a Remote Device Intercom Paging Signal Not ReceivedOperation During a Power Failure Cannot Use DND, TIMER, Allpage or SETExpanding the 954 System Setting Up a Fourth Line for Each Station Setup ChecklistCentrex Operation Enabling/Disabling Attendant StationAnswering a Delayed Ring Setting Ring Delay DurationAttendant Operation Picking Up Another Station’s Line Page Page