Lucent Technologies 954 Directory Card, Storing Numbers in Memory, Erasing Memory Numbers

Page 22

TELEPHONE MEMORY

Directory Card

Remove the directory card and write in the numbers (or names) you want to store in each memory location.

Storing Numbers in Memory

1Press and release G.

2Enter the telephone number you want to store (up to 16 digits)

— OR —

Press and release Rto store the last number dialed.

3Press the memory button where you want to store the number

— OR —

Press land the memory button where you want to store the number.

Storing a Pause in a Memory Number

To store a dialing pause in a memory number, press and release Pwhere you want the dialing pause to occur. Each time you press P, you enter a two-second pause in the dialing sequence.

Storing a Temporary Tone Signal in a Memory Number

To store a tone signal, press and release twhere you want tone dialing to begin. All digits entered after this will send tone signals.

Storing Flash in a Memory Number

You can store the switchhook flash needed to access some custom-calling services in a memory number. Press and release Fwhere you want the switchhook flash to occur in the dialing sequence.

Erasing Memory Numbers

To remove a number from memory, you can store another number in its place. To clear a memory location and leave it empty:

1Press and release G.

2Press and release P.

3Press the memory location to be erased

— OR —

Press land the memory location to be erased.

20

Lucent 0954 book.L1

20

5/7/98, 10:36 AM

Image 22

Contents User’s Manual for Four-Line Intercom/ Speakerphone Philips Consumer Communications L.P. All rights reserved Contents Lucent 0954 book.L1 98, 1034 AM Before YOU Begin Install 3 AAA batteries InstallationTable/Desk Installation Connect the telephone line cords to the telephoneConnect the handset cord Connect the power adapterCheck for dial tone Wall Installation Reverse the handset tabConnect the power adapter to the telephone Mount the phone on the wall Standard Electrical Outlet Convenience Port Assign Intercom Number Telephone Feature SetupSet Dial Mode Set the ClockChange Battery Display Set Up for a Private LineSet for Two or Three Phone Lines Operation Call Privacy Making a CallLine-In-Use Lights Ringer Volume VolumeHandset/Speakerphone Volume Control Turning Ringer OffAuto Redial Switch Between LinesRedial HoldTemporary Tone Dialing MuteFlash Conference CallsTransferring an Announced Call Do Not DisturbTransfer a Call Transferring an Unannounced CallTimer Telephone Memory Storing Numbers in Memory Storing a Temporary Tone Signal in a Memory NumberDirectory Card Storing a Pause in a Memory NumberIntercom Operation Answering an Intercom Call or Basic Intercom OperationsMaking an Intercom Call or Ending an Intercom Call orMaking an Intercom Conference Call Paging All PhonesAnswering an Allpage Room MonitorCase of Difficulty Operation During a Power Failure Intercom Paging Signal Not ReceivedTone Signals Do Not Activate a Remote Device Cannot Use DND, TIMER, Allpage or SETExpanding the 954 System Centrex Operation Setup ChecklistSetting Up a Fourth Line for Each Station Enabling/Disabling Attendant StationAnswering a Delayed Ring Setting Ring Delay DurationAttendant Operation Picking Up Another Station’s Line Page Page