Lucent Technologies 954 user manual Wall Installation, Reverse the handset tab

Page 8

INSTALLATION

Wall Installation

1Reverse the handset tab.

Hold down the switchhook, then pull the tab out and rotate it 180 degrees. Release the tab so it settles into position.

2Install 3 AAA batteries.

•Press in on the tabs and remove the telephone base.

•Press in on the tabs on the battery door, and remove it.

•Insert 3 AAA batteries, and replace the battery door.

3Turn the base, as shown, and attach it to the bottom of the phone.

6

Lucent 0954 book.L1

6

5/7/98, 10:34 AM

Image 8

Contents User’s Manual for Four-Line Intercom/ Speakerphone Philips Consumer Communications L.P. All rights reserved Contents Lucent 0954 book.L1 98, 1034 AM Before YOU Begin Installation Table/Desk InstallationInstall 3 AAA batteries Connect the telephone line cords to the telephoneCheck for dial tone Connect the power adapterConnect the handset cord Wall Installation Reverse the handset tabConnect the power adapter to the telephone Mount the phone on the wall Standard Electrical Outlet Convenience Port Telephone Feature Setup Set Dial ModeAssign Intercom Number Set the ClockSet for Two or Three Phone Lines Set Up for a Private LineChange Battery Display Operation Line-In-Use Lights Making a CallCall Privacy Volume Handset/Speakerphone Volume ControlRinger Volume Turning Ringer OffSwitch Between Lines RedialAuto Redial HoldMute FlashTemporary Tone Dialing Conference CallsDo Not Disturb Transfer a CallTransferring an Announced Call Transferring an Unannounced CallTimer Telephone Memory Storing a Temporary Tone Signal in a Memory Number Directory CardStoring Numbers in Memory Storing a Pause in a Memory NumberIntercom Operation Basic Intercom Operations Making an Intercom Call orAnswering an Intercom Call or Ending an Intercom Call orPaging All Phones Answering an AllpageMaking an Intercom Conference Call Room MonitorCase of Difficulty Intercom Paging Signal Not Received Tone Signals Do Not Activate a Remote DeviceOperation During a Power Failure Cannot Use DND, TIMER, Allpage or SETExpanding the 954 System Setup Checklist Setting Up a Fourth Line for Each StationCentrex Operation Enabling/Disabling Attendant StationAttendant Operation Setting Ring Delay DurationAnswering a Delayed Ring Picking Up Another Station’s Line Page Page