Yamaha HTR-6180 owner manual 121 En, After AUTO SETUP, Notes

Troubleshooting

After AUTO SETUP

Warning message	Cause	Remedy	See
			page

W-1:OUT OF PHASE	Speaker polarity is not correct. This message
	may appear depending on the speakers even
	when the speakers are connected correctly.

Check the speaker connections for proper	14
polarity (+ or –).

W-2:OVER 24m (80ft)	The distance between the speaker and the	Bring the speaker closer to the listening	—
	listening position is over 24 m (80 ft).	position.
W-3:LEVEL ERROR	The difference of volume level among	Readjust the speaker installation so that all	—
	speakers is excessive.	speakers are set in locations with similar
		conditions.
		Check the speaker connections.	14
		Use speakers of similar quality.	—
		When “SWFR: TOO LOUD”or “SWFR:	32
		TOO LOW” appears in the result screen, the
		output volume of the subwoofer.

W-4:CHECK PRNS	“EXTRA SP ASSIGN” is set to
	“PRESENCE”, though the presence channel
	signals are not detected.

Check the presence speaker connections.	14
Set “EXTRA SP ASSIGN” to a setting other	33
than “PRESENCE”.

Notes

•If the “ERROR” or “WARNING” screens appears, check the cause of the problem, then run “AUTO SETUP” again.

•If a warning message “W-1”, “W-2”, or “W-3” appears, corrections are made, but they may not be optimal.

•If an error message “E-10” occurs repeatedly, contact a qualified Yamaha service center.

INFORMATION ADDITIONAL

English

121 En