
Customizing this unit (MANUAL SETUP)
Bass cross over CROSS OVER
Use this feature to select the crossover frequency of all the speakers set to “SML” (or “SMALL”) in “SPEAKER SET” (see page 87). All frequencies below the selected frequency will be sent to the subwoofer(s) or front speakers depending on the setting of “LFE/BASS OUT” in “SPEAKER SET” (see page 87).
Choices: 40Hz, 60Hz, 80Hz, 90Hz, 100Hz, 110Hz, 120Hz, 160Hz, 200Hz
A)SPEAKER SET
CROSS OVER
FREQ;;;;80Hz
■Speaker level B)SP LEVEL
Use this feature to manually balance the speaker levels between the front left or surround left speakers and each speaker selected in “SPEAKER SET” (see page 87). Control range:
Control step: 0.5 dB Initial setting: FR.L/FR.R/SWFR/PR.L/PR.R: 0 dB CNTR/SUR.L/SUR.R/SBL/SBR:
B)SP LEVEL | 1/2 |
| B)SP LEVEL | 2/2 |
. FR.L |
|
| . SBL |
|
FR.R |
|
| SBR |
|
CNTR |
|
| SWFR |
|
SUR.L |
|
|
|
|
SUR.R |
|
|
|
|
y
If your subwoofer can adjust the output volume and the crossover frequency, set the volume to about half way (or slightly less) and set the crossover frequency to the maximum.
Subwoofer phase SUBWOOFER PHASE
Use this feature to switch the phase of your subwoofer if bass sounds are lacking or unclear.
A)SPEAKER SET
SUBWOOFER PHASE
>NORMAL REVERSE
ChoiceFunctions
NORMAL Does not change the phase of your subwoofer.
(normal)
REVERSE Sets the phase of your subwoofer to reverse.
(reverse)
SP LEVEL | Adjusted speaker |
|
|
FR.L | Front left speaker |
|
|
FR.R | Front right speaker |
|
|
CNTR | Center speaker |
|
|
SUR.L | Surround left speaker |
|
|
SUR.R | Surround right speaker |
|
|
SBL | Surround back left speaker |
|
|
SBR | Surround back right speaker |
|
|
SWFR | Subwoofer |
|
|
PR.L | Presence left speaker |
|
|
PR.R | Presence right speaker |
|
|
y
•If your subwoofer can adjust the output volume and the crossover frequency, set the volume to about half way (or slightly less) and set the crossover frequency to the maximum.
•Set “TEST TONE” to “ON” to output the test tone for the “SPEAKER LEVEL” setting (see page 90).
Notes
•The available speaker channels differ depending on the setting of the speakers.
•Instead of “SBL” and “SBR”, “SB” is displayed if “SUR. B L/R SP” is set to either “SMLx1” or “LRGx1” (see page 88).
OPERATION | ADVANCED |
|
|
English