![](/images/new-backgrounds/1006628/6628129x1.webp)
Before performing the following operations, set the operation mode selector on the remote control to FSOURCE and then press 4XM.
■All Channel Search mode
1Press BSEARCH MODE (or ISRCH MODE) repeatedly to select “ALL CH
SEARCH”.
2Press EPRESET/TUNING/CH l / h (or
8PRESET/CH k / n) repeatedly to search for a channel within all channels.
y
•You can search for a channel quickly by pressing and holding
EPRESET/TUNING/CH l/ h(or 8PRESET/CH k/ n).
•To display the XM Radio ID number displayed in the front panel display, select channel “0”.
XM Satellite Radio tuning
3Press EPRESET/TUNING/CH l/ h (or
8PRESET/CH k/ n) repeatedly to change the preset channel number (1 to 8).
y
You can also select the preset channel number directly by pressing the numeric buttons (1 to 8) (6).
■Direct number access mode
1Press ISRCH MODE on the remote control repeatedly to select “ALL CH SEARCH” or “CAT SEARCH”.
2Press the numeric buttons (6) to enter the desired
For example, to enter the number 123, press the numeric buttons (6) as shown below.
■Category Search mode
1Press BSEARCH MODE (or ISRCH MODE) repeatedly to select “CAT SEARCH”.
2Press DCATEGORY (or
3Press EPRESET/TUNING/CH l / h (or
8PRESET/CH k / n) repeatedly to search for a channel within the selected channel category.
y
You can search for a channel quickly by pressing and holding
EPRESET/TUNING/CH l/ h(or 8PRESET/CH k/ n).
■Preset Search mode
Prior to selecting a preset channel in the Preset Search mode, you must preset XM Satellite Radio channels. For details, see “Setting the XM Satellite Radio preset channels” on page 62.
y
The initial factory setting of all preset channels (A1 to E8) is “001 Preview”.
1Press BSEARCH MODE (or ISRCH MODE) repeatedly to select “PRESET
SEARCH”.
2Press DCATEGORY (or
1 | 2 | 3 |
|
|
y
•To enter a
•Instead of pressing HENT to tune into the channel immediately, you can wait a few seconds until this unit confirms the entered channel number.
•Pressing a button other than the numeric buttons (6) or HENT cancels the Direct Number Access mode procedure.
OPERATION | BASIC |
English