Using
■Using the internal amplifier of this unit
Important safety notice
The EXTRA SP speaker terminals of this Receiver should not be connected to a Passive Loudspeaker Selector Box or more than one loudspeaker per channel.
Connection to a Passive Loudspeaker Selector Box or multiple speakers per channel could create an abnormally low impedance load resulting in amplifier damage. See this owner’s manual for correct usage.
Compliance with minimum speaker impedance information for all channels must be maintained at all times. This information is found on the back panel of your Receiver.
Connect the speakers in the second zone to the EXTRA SP speaker terminals and then set the “EXTRA SP ASSIGN” to “ZONE2” (see page 87).
Second zone
(Zone 2)
FRONT B/ZONE2/
PRESENCE
REXTRA SP L
This unit
Main zone
y
•You can use the speakers connected EXTRA SP speaker terminals as the front speaker system of another zone. Set “EXTRA SP ASSIGN” to “ZONE B” (see page 87).
•When you use the internal amplifiers for the Zone 2 speakers, you can adjust the volume level and set the initial volume level and maximum volume level of the Zone 2 speakers (see page 101).
OPERATION | ADVANCED |
Controlling Zone 2
You can select and control Zone 2 by using the control buttons on the front panel or on the remote control. The available operations are as follows:
•Selecting the input source of Zone 2.
•Tuning into FM or AM when “TUNER” is selected as the input source of Zone 2 (see page 53).
•Tuning into XM Satellite Radio when “XM” is selected as the input source of Zone 2 (see page 59) (U.S.A. and Canada models only).
•Tuning into SIRIUS Satellite Radio when “SIRIUS” is selected as the input source of Zone 2 (see page 64) (U.S.A. and Canada models only).
•Enjoying music stored on your iPod stationed in a Yamaha iPod universal dock (such as
■Controlling Zone 2 with the front panel
Turning on Zone 2
Press HZONE 2 ON/OFF to turn on Zone 2.
Activating the Zone 2 operation mode
Press IZONE CONTROL to control Zone 2.
The ZONE2 indicator flashes in the front panel display for approximately 10 seconds.
ZONE2
Flashes
Note
You must complete each step while the ZONE2 indicator is flashing in the front panel display. Otherwise, the Zone 2 mode is automatically canceled and this unit returns to the normal operation mode. In this case, repeat the Zone 2 selection procedure.
English
