
Optimizing the speaker setting for your listening room (YPAO)
7 Press 8n to select “START” and then press | 9 Make sure that the following screen appears | |
8ENTER to start the setup procedure. | and then press 8ENTER to display the | |
The following message appears in the OSD. | result screen. | |
When this unit starts the automatic setup procedure, |
| |
loud test tones are output at the speakers. | AUTO | |
| ||
For more accurate measurements, keep quiet and | Measurement Complete | |
move to the wall where speakers are not around. We | ||
| ||
recommend that you leave the listening room during | Press [ENTER] | |
the automatic setup procedure. | ||
| ||
NOTICE |
| |
Loud |
| |
Please | AUTO | |
| ||
or | RESULT | |
| ||
| SP : 3/4/0.1 | |
Press | DIST: 14.0/17.0ft | |
| LVL : | |
| . >SET CANCEL |
Once you perform the next operation, this unit starts the automatic setup procedure.
8Press 8ENTER to start the automatic setup procedure.
The following screen appears in the OSD and setup procedure starts in 10 seconds.
AUTO
Measurement in 9
[RETURN]:Cancel
Loud test tones are output from each speaker during the auto setup procedure. Once all items are set, the “RESULT” display appears in the OSD.
Notes
[]/[ ]:Up/Down [ENTER]:Enter
The results displayed under “RESULT” are as follows:
Number of speakers SP
Displays the number of speakers connected to this unit in the following order: Front/Back/Subwoofer
Speaker distance DIST
Displays the speaker distance from the listening position in the following order:
Closest speaker distance/Farthest speaker distance
Speaker level LVL
Displays the speaker output level in the following order:
Lowest speaker output level/Highest speaker output level
•During the automatic setup procedure, do not perform any operation on this unit.
•We recommend that you get out of the room while this unit is in the auto setup procedure. It takes approximately 3 minutes for this unit to complete the auto setup procedure.
y
Press 8kto cancel the automatic setup procedure.
Notes
•The signal output at the SUBWOOFER PRE OUT 2 jack is the same as the one output at the SUBWOOFER PRE OUT 1 jack. Therefore, even if you connect two subwoofers, the number of the connected subwoofer is indicated as “0.1”.
•If
•If you selected other than “AUTO” in step 5, no test tones are output.
•If an error occurs during the “AUTO SETUP” procedure, the setup procedure is canceled and an error screen appears. For details, see “If an error screen appears” on page 36.
•When this unit detects potential problems during the “AUTO SETUP” procedure, “WARNING” and the number of warning messages appears in the above of “RESULT” (see page 36).
•Depending on the listening environment, “SWFR PHASE:REV” appears during the automatic procedure and “SUBWOOFER PHASE” in “SOUND MENU” (see page 89) is automatically set to “REVERSE”.