
Connections |
|
Connecting the power cable | Setting the speaker impedance |
(U.S.A. model)
MONITOR OUT | C | DVR |
AC OUTLETS |
|
|
SWITCHED |
|
|
120V 80Hz |
|
|
100W MAX. TOTAL |
|
|
0.8A MAX. TOTAL |
|
|
To the AC wall outlet
■AC OUTLETS (SWITCHED)
Use these 2 outlets to supply power to any connected components. Connect the power cable of your other components to these 2 outlets. Power to these 2 outlets is supplied when this unit is turned on. However, power to these 2 outlets is cut off when this unit is turned off. For information on the maximum power or the total power consumption of the components that can be connected to these 2 outlets, see “Specifications” on page 127.
Note
The power to AC OUTLETS of this unit is not cut off while this unit is charging connected iPod even when this unit is in the standby mode. When this unit completes charging or the iPod is disconnected, the power is cut off automatically when this unit is in the standby mode.
Memory back-up
The memory
Caution
If you are to use 6 ohm speakers, set “SP IMP.” to
“6Ω MIN” as follows BEFORE using this unit. 4 ohm speakers can be also used as the front speakers.
1Press LSYSTEM OFF on the front panel to turn off this unit.
See page 29 for details.
2Press and hold MTONE CONTROL and then press KMAIN ZONE ON/OFF to turn
on this unit.
This unit turns on, and the advanced setup menu appears in the front panel display.
TONE CONTROL | While holding | MAIN ZONE |
| down | ON/OFF |
3Rotate the NPROGRAM selector to select “SP IMP.”.
“SP IMP.” and the current speaker impedance setting (“8Ω MIN”) appear in the front panel display.
4Press MTONE CONTROL repeatedly to select “6Ω MIN”.
5Press LSYSTEM OFF to save the new setting and turn off this unit.
Note
The setting you made is reflected next time you turn on this unit.