Yamaha HTR-6180 16 En, Connecting the speaker cable, Using bi-amplificationconnections

Connections

■Connecting the speaker cable

1Remove approximately 10 mm (0.4 in) of insulation from the end of each speaker cable and then twist the exposed wires of the cable together to prevent short circuits.

10 mm (0.4 in)

■Connecting the banana plug (U.S.A. and Canada models only)

Tighten the knob and then insert the banana plug connector into the end of the corresponding terminal.

2Loosen the knob.

Red: positive (+)

Black: negative (–)

3Insert one bare wire into the hole on the side of each terminal.

4Tighten the knob to secure the wire.

Red: positive (+)

Black: negative (–)

■Using bi-amplification connections

Caution

Remove the shorting bars or bridges of your speakers to separate the LPF (low pass filter) and HPF (high pass filter) crossovers.

This unit allows you to make bi-amplification connections to one speaker system. Check if your speakers support bi- amplification.

To make the bi-amplification connections, use the FRONT and SURROUND BACK/BI-AMP terminals as shown below. To activate the bi-amplification connections, set “BI-AMP” to “ON” in “ADVANCED SETUP” (see page 112).

Front speakers

Right Left

	FRONT A	SURROUND BACK/
			BI-AMP
R	L	R	SINGLE L

This unit

Note

When you make the conventional connection, make sure that the shorting bars are put into the terminals appropriately. Refer to the instruction manuals of the speakers for details.

16 En