2Setting up your phone
Installing your DECT 2250
1.Place 2 rechargeable NiMH AAA batteries (included), in correct polarities, into the battery compartment on the handset. Note : the warranty shall not apply to the batteries and any other components within lifetime and wear.
2.Slide the battery door firmly into place.
3.Place the handset on the base unit or the charger and let the batteries continuously charge for 24hours before using.A beep indicates that the handset is properly placed on the base unit or the charger.The handset may take some time to power up and it may get warm during the initial charge.
This is normal.
Select the language
1. Press twice the MENU key. LANGUAGE appears on the screen.
2. Press the OK key.The current language is shown on the screen.
3.Select the desired language.
4.Press the OK key to confirm.
If you need to change the language again, see description on page 8.
Registering your handset
You will need to register your handset if it shows NOT REG in the display or if you wish to
To register your handset:
1.Press the MENU key.
2.Select SETTINGS and press the OK key.
3.Select REGISTERand press the OK key.
4. Before OK key is pressed when REGISTER is selected, press and hold the PAGING key on the base for 4 seconds until a registration tone is emitted (DECT 225 only). The base is now in the registration mode. (If the base is full and cannot take on any more handset, it will emit a reject tone instead (DECT 225 only) and you will not be able to register any more handset. See Section 9 -
5.Press the OK key while REGISTER is selected.
During the registration period, you will see SEARCHNG on the handset.
You will hear a confirmation tone if the registration is successful. The handset label and the handset number will be displayed. If the registration is not successful, the previously unregistered handset will display NOT REG again and the previously registered handset will connect back to its original base again. Follow the procedure and try again.
4 | SETTING UP YOUR PHONE |