Panasonic KX-TG1062M, KX-TG1063, KX-TG1061 Error messages, Display message Cause/solution

Page 41

Useful Information

Error messages

If the unit detects a problem, one of the following messages is shown on the display.

Display message	Cause/solution
Busy	L The called unit is in use.
	L Other units are in use and the system is busy. Try again
	later.
	L The handset you are using is too far from the base unit.
	Move closer and try again.
	L The handset’s registration may have been canceled. Re-
	register the handset (page 27).
Check tel line	L The supplied telephone line cord has not been connected
	yet or not connected properly. Check the connections
	(page 8).
Error!!	L Recording was too short. Try again.
Failed	L Phonebook copy failed (page 19). Confirm the other unit
	(the receiver) is in standby mode and try again.
Incomplete	L Phonebook copy is incomplete. The receiver’s phonebook
	memory is full. Erase the unnecessary phonebook entries
	(page 17) from the other unit (the receiver) and try again.
Memory full	L The phonebook memory is full. Erase unnecessary
	entries (page 17).
	L Message memory is full. Erase unnecessary messages
	(page 32, 33).
Messages full	L Message memory is full. Erase unnecessary messages
	(page 32, 33).
No link. Reconnect base AC	L The handset has lost communication with the base unit.
adaptor.	Move closer to the base unit and try again.
	L Unplug the base unit’s AC adaptor to reset the unit.
	Reconnect the adaptor and try again.
	L The handset’s registration may have been canceled. Re-
	register the handset (page 27).
Requires subscription to	L You must subscribe to a Caller ID service. Once you
Caller ID.	receive caller information after subscribing to a Caller ID
	service, this message will not be displayed.
Use rechargeable battery.	L A wrong type of battery such as Alkaline or Manganese
	was inserted. Use only the rechargeable Ni-MH batteries
	noted on page 4, 5.

For assistance, please visit http://www.panasonic.com/help

41

Image 41

Contents Operating Instructions Table of Contents Supplied accessories Accessory informationModel composition Series Model No Base unit Handset QuantityAccessory item Order number Additional/replacement accessoriesExpanding your phone system Handset optional KX-TGA106For your safety Important safety instructions Other information Battery installation Setting upBattery charge ConnectionsBattery level Icon During a power failureHandset ControlsBase unit Soft keys Using the navigator key/volume key VOL., ?Display Dialing mode Initial settingsDisplay language Voice guidance languageMaking calls Hold Useful features during a callAnswering calls Temporary tone dialing for rotary/pulse service users For call waiting or Call Waiting Caller ID service usersMute FlashGroups Base unit/handset phonebookAdding entries Erasing entries Finding and calling a phonebook entryEditing entries Canceling a speed dial assignment Making a call using a speed dial buttonSpeed dial Chain dialCopying an entry Copying phonebook entriesCopying all entries OFFProgramming by scrolling through the display menus Programmable settings= Base unit / YHandset Menu Base unit Main menu Sub-menuHandset Main menu Sub-menu Operating Feature Setting System Unit Code Programming using the direct commandsHandset*7 VM tone detect Special programming Silent modeAlarm Call block Caller ID subscribers only Operating additional units Registering a unitRegistering a handset to a base unit Additional handsetsCaller ID features Using Caller ID serviceCaller list Group ringer tone for phonebookEditing a caller’s phone number before calling back Caller ID number auto edit featureExample Turning Caller ID auto edit on/off = Base unit / YHandsetStoring caller information to the phonebook Erasing selected caller informationErasing all caller information Greeting message Answering systemTurning the answering system on/off Listening to messages using the base unit Operating the answering system Listening to messages using the handsetMenu iPLAY To listen to new messagesUsing the answering system remotely Remote access codeRemote commands Remote operationSave iOFF For voice mail service subscribers Answering system settingsTurning on the answering system remotely Number of rings before the unit answers a callTurning the call screening on/off Message alertVoice mail message indication Voice mail serviceVoice mail VM tone detection Turning VM tone detection on/offHandset locator IntercomTransferring calls, conference calls Making an intercom callTo establish a conference call Press Conf To transfer the callTo transfer the call Press OFF Answering a transferred call = Base unitBelt clip Wall mountingCharger To attachDisplay message Cause/solution Error messagesGeneral use Problem Cause/solution TroubleshootingProgrammable settings Problem Cause/solution Battery recharge Problem Cause/solutionCaller ID Problem Cause/solution Problem Cause/solutionAnswering system Problem Cause/solution Liquid damage Problem Cause/solution FCC and other information FCC RF Exposure Warning Instalación Guía Rápida EspañolaIdioma de la guía de voz Auricular predeterminado inglés Operaciones básicas Para grabar su propio mensaje Mensaje marcador Preguntas frecuentes 1El auricular inalámbrico muestra Solución rápida de problemasReconecte Reconecte Adaptador Hablar 2El auricular no emite ningún tono de marcaciónCómo registrar un auricular en la unidad base Customer Services Directory United States and Puerto Rico Customer servicesShip-In Service Warranty For United States and Puerto RicoOne Panasonic Way, Secaucus, New Jersey Parts Labor One 1 YearLimited Warranty Limits And Exclusions Index Call us at 1-800-211-PANA Read these Operating InstructionsFor your future reference Copyright