Connecting audio sources to the transmitter
You can connect audio sources such as a CD player, a television, or the sound card of a computer to the line input of the transmitter.
Connect the 3.5 mm jack plug of the connecting cable to the transmit- ter’s 3.5 mm jack socket (LINE) .
Via the operating menu, adjust the sensitivity of the line input (see “Adjusting the sensitivity of the line input“ on page 82).
Note:
If the transmitter is preset so that the line input is switched off, the dis- play for line level is not shown on the display panel.
Connecting the receiver to hearing aids or headphones
Connecting the receiver to hearing aids with direct audio input
Connect a hearing aid with direct audio input to the receiver’s 2.5 mm jack socket (LOW) . Suitable connecting cables (see “System variants and accessories“ on page 103) are available from your Sennheiser dea- ler.
Connecting the receiver to a hearing aid without audio input (hearing aid must have Telecoil)
Connect the EZT 2015 induction neck loop or the EZI 120 induction couplers for hearing aids without audio input to the receiver’s 3.5 mm jack socket (HI) . Suitable connecting cables for the induction coup- lers (see “System variants and accessories“ on page 103) are available from your Sennheiser dealer.
Connecting the headphones
You must only connect headphones with a stereo jack plug and a minimum impedance of 32 Ω to the receiver (see “Connector assignment“ on page 102).
Connect the headphones to the receiver’s 3.5 mm jack socket (HI) .
70