Sennheiser 2015 manual Entering a name, Resetting the unit to the factory-preset default settings

	Press the SET button to store your setting.
	Entering a name
NAME	Via the “NAME” menu, you can enter a freely selectable name for the trans-
	mitter or receiver. This name is briefly shown on the display panel after
	switch-on.
	The name can consist of up to six characters such as:
	y letters (without pronounciation marks),
	y numbers from 0 to 9,
	y special characters e.g. () - . _ and spaces.
	To enter a name, proceed as follows:
	After you have entered into the setting mode of the menu, the first seg-
	ment starts flashing on the display.
	Use the / rocker button (UP/DOWN) to select a character. By briefly
	pressing the button, the display jumps either forwards or backwards to
	the next character. If you hold down the button, the display starts cyc-
	ling continuously.
	Press the SET button to change to the next segment.
	After you have entered the name completely press the SET button to
	store your setting and to return to the top menu level.
	Resetting the unit to the factory-preset default settings
RESET	Via the “RESET” menu, you can reset the unit to the factory-preset default
	settings. In order to prevent an accidental reset, a safety query appears on
	the display. You can select “NO” or “OK”.

y“NO”: If you select “NO” and confirm your selection by pressing the SET button, the reset of the unit is cancelled and you return to the configuration menu.

y“OK”: If you select “OK” and confirm your selection by pressing the SET button, the unit is reset to the factory-preset default set- tings. After the reset, the unit is restarted and “SETUP” appears on the display.

96