Sennheiser manual Recommendations and tips, For system planning, For the SK 2015 transmitter

Page 33

Problem

Possible cause

Possible solution

 

 

 

No access to a certain

The channel has not been released.

Set transmitter and receiver to a

channel

 

different channel.

 

 

 

 

 

The technical expert must release the

 

 

channel.

 

 

 

If problems occur that are not listed in the above table or if the problems cannot be solved with the pro- posed solutions, please contact your technical expert for assistance.

Recommendations and tips

... for system planning

yTransmitter and receiver of a transmission link must be set to the same frequency.

yA transmitter can be received by several receivers on the same frequency.

yHowever, a receiver cannot receive several transmitters on the same frequency. Incorrect settings are indicated by crackling and chirping in the receiver.

... for the MKE 2015-0 plug-on microphone (optional accessory)

yAdjust the length of the neck strap so that the distance between the microphone and your mouth is 9.8 inches at the most.

yThe plug-on microphone allows you to transmit group discussions. For this purpose, place the trans- mitter on the table on a soft and springy pad.

... for the ME 2015-H headset microphone (optional accessory)

yAlways use the microphone with a popshield and position the microphone at the corner of the mouth.

yYou can vary the bass reproduction by increasing/decreasing the talking distance.

yMake sure that the sound inlet is directed towards the mouth. The sound inlet is marked with a little dot.

... for the SK 2015 transmitter

yMake sure that the antenna and the microphone cable do not cross.

yFor best results, make sure that the transmitter sensitivity is correctly adjusted.

85

Image 33
Contents Mikroport System 105 Bedienungsanleitung157 209Mikroport System Safety instructions Contents 102 Warranty regulationsOperating principle of the 2015 Mikroport System 2015 Mikroport SystemDelivery includes MKE2015 EZB Transport case Transport holding device EZG Operating controls of the EK 2015 receiver Audio signal indication Battery status indicationIndications and displays on the receiver Alphanumeric displayDisplay for the audio level Display for lock modeDisplay for microphone level internal microphone Display for the RF levelOperating controls of the SK 2015 transmitter Indications and displays on the transmitter Red LED flashing Battery pack or the batteriesMute indication Audio peak indicationDisplay for microphone level Display for line levelPreparing the units for use Transporting the transmitter and receiverTransport case Transport holding device Connecting sound sources to the transmitter How to properly use the battery pack or the batteriesConnecting the microphones to the transmitter MKE ME 2015-H Attaching and positioning the microphonesConnecting the receiver to hearing aids or headphones Connecting audio sources to the transmitterConnecting the headphones Wearing the transmitter or receiver around your neck Attaching the transmitter or receiver to clothingUsing the receiver Switching the receiver on/offActivating/deactivating the lock mode Adjusting the level of the received audio signal Adjusting the level of the internal microphoneSwitching the channel Displaying the frequency MIC Operating menu of the EK 2015 receiverUsing the transmitter Switching the transmitter on/offMuting the microphone Activating/deactivating the lock mode Function of the buttons Working with the transmitter’s operating menuGetting into the operating menu Adjusting a settingSelecting a menu Press the / rocker button UP/DOWN to select a menuStoring a setting Overview of menusExiting the operating menu Operating menu Operating menu of the SK 2015 transmitterAdjustment tips for the operating menu of the transmitter Adjusting the microphone sensitivityAdjusting the sensitivity of the line input Switching between the channels Nel that is released on all receiversTion-free Error checklist TroubleshootingFor the ME 2015-H headset microphone optional accessory For the MKE 2015-0 plug-on microphone optional accessoryRecommendations and tips For system planningCare and maintenance For optimum receptionFor multi-channel operation Working with the configuration menu Configuration of the units by the technical expertGetting into the configuration menu Exiting the configuration menu Reset Structure of the configuration menu of the EK 2015 receiverAccess Reset Switching the internal microphone on or off receiver only Adjustment tips for the configuration menuAdjusting the squelch threshold receiver only Receiver onlyReleasing channels for the user Then displays the next channel that can be released Press the SET button and the button UP simultaneouslyPlay Mitter and receiverEntering a name Resetting the unit to the factory-preset default settingsChanging the battery compartment cover Colored battery doors and face platesClose the battery compartment Changing the face plate receiver onlyChannel bank system Additional informationRange B Range CHDX noise reduction system RF link Inherent Noise of the RF link TransmitterYou can hear the difference Mikroport System SpecificationsOFF EK 2015 receiverConnector assignment SK 2015 transmitterMm stereo jack plug, unbalanced Mm mono jack plug 102 System variants and accessories 104 NT 3-USGarantiebestimmungen Garanzia prodotti Conditions de garantieDeclaración de garantia Page FCC DMOB2AUWG Nota BemerkungObservación OpmerkingPage
Related manuals
Manual 4 pages 9.73 Kb