Adjustment tips for the operating menu of the transmitter
Adjusting the microphone sensitivity
SENSIT (MIC) | Via the “SENSIT (MIC)” menu, you can adjust the sensitivity of the con- | |
| nected microphone in 32 steps. The microphone sensitivity is correct | |
| adjusted when the display for microphone level (MIC) | shows full deflec- |
| tion only when you speak very loudly. The yellow LED | should only light |
| up briefly. |
|
| Note: |
|
| For monitoring the adjusted microphone sensitivity, the display for | |
| microphone level (MIC) is always indicated – even when the micro- | |
| phone is muted. |
|
| Adjusting the sensitivity of the line input |
|
SENSIT (LINE) | Via the “SENSIT (LINE)” menu, you can adjust the sensitivity of the line | |
| input in 32 steps. |
|
| The input sensitivity is adjusted too high when loud passages cause over- | |
| modulation in the transmission link. In this case, the yellow LED will light | |
| up for longer periods of time. If, on the other hand, the sensitivity is | |
| adjusted too low, the transmission link will be undermodulated, which | |
| would result in a signal with high background noise. |
|
| The sensitivity is correctly adjusted when the display for line level (LINE) | |
| shows full deflection only during the loudest passages. |
|
| Note: |
|
| If the sensitivity of the line input is set to “OFF”, the display for line level | |
| (LINE) is not shown on the display panel. |
|
82