Uniden EXS 2050 manual Mounting the base unit on a wall, Standard wall plate mounting

Page 11

Mounting the base unit on a wall

Standard wall plate mounting

This phone can be mounted on any standard telephone wall plate.

1

2 - 7

1 Snap the wall mount adapter into the notches on the base.

2 Plug the telephone line cord to the

TEL LINE jack and the AC adapter to the DC IN 9V jack.

3 Plug the telephone line cord into the telephone outlet.

4 Wrap the AC adapter cord inside the molded wiring channel. Then wrap the cord around the strain relief notch.

5 Plug the AC adapter into a standard

120V AC wall outlet.

6 Raise the antenna to a vertical position.

7 Align the mounting slots on the base with the mounting posts on the wall. Push in and down until the phone is firmly seated.

8

Image 11
Contents Page Introduction FeaturesTalk Flash Controls and functions43 44 45 Contents Handset Read this firstBase unit Checking the package contents Choose the best location Setting up the base unitConnect the base unit If you want to install the base unit on the wall, seeIf you arent sure of your dialing system Choose the dialing modeIf your dialing system is Set the switch to Tone PulseStandard wall plate mounting Mounting the base unit on a wallDirect wall plate mounting Use only Uniden Battery BT-905 supplied with your phone Installing the handset battery packDo not use any liquids or solvents Battery use time per chargeWhen the battery charge becomes low Cleaning the charging contactsOther Operations Making a callRinger mute Receiving a callFrom the handset From the baseHandset ringer tone and volume Adjusting the volumeMute Flash and Call WaitingRedialing a call Traveling out-of-range Using the page featureStoring phone numbers Chain dialing Making calls with memory dialing Memory dialingErasing a stored phone number Way conferencing When speaking on the handsetWhen speaking on the base Integrated answering device Turning the answering system on/off Setting up your answering systemChoosing between the two outgoing messages Setting your greetingPreset Message Recording a personal outgoing message GreetingSelecting a PIN code Announce only featureSelecting the message record time Setting ring time switch Playing your messages Using your answering systemSkipping a message Repeating a messageDeleting all messages Deleting a messageVoice memo Deleting individual messagesRecording a conversation Command Function # then Repeat Remote access away from homeRemote room monitor Changing the digital security code To remove the beltclip Installing the beltclipHeadset installation To attach the beltclipBattery replacement and handling MaintenanceSymptom Suggestion TroubleshootingSymptom Suggestion At Uniden, we’ll take care of you W, X, Y, Z IndexK, L