Uniden EXS 2050 manual Installing the handset battery pack

Page 13

Installing the handset battery pack

Charge the battery pack for 15-20 hours before you start using your phone.

1 Press in on the battery cover release and slide the cover down until it comes off.

2 Connect the battery pack connector with the correct polarity (black and red wires), then insert the battery pack into the battery compartment.

3

4

Slide the battery cover forward until it snaps into place.

Place the handset on the base.

5 Make sure that the “status” LED lights. If the LED doesn’t light, check to see that the AC adapter is

status LED

plugged in and that the handset makes good contact with the base charging contacts.

Use only Uniden Battery (BT-905) supplied with your phone.

10

Image 13

Contents Page Introduction FeaturesTalk Flash Controls and functions43 44 45 Contents Base unit Read this firstHandset Checking the package contents Choose the best location Setting up the base unitConnect the base unit If you want to install the base unit on the wall, seeIf your dialing system is Set the switch to Tone Choose the dialing modePulse If you arent sure of your dialing systemStandard wall plate mounting Mounting the base unit on a wallDirect wall plate mounting Use only Uniden Battery BT-905 supplied with your phone Installing the handset battery packWhen the battery charge becomes low Battery use time per chargeCleaning the charging contacts Do not use any liquids or solventsOther Operations Making a callFrom the handset Receiving a callFrom the base Ringer muteHandset ringer tone and volume Adjusting the volumeRedialing a call Flash and Call WaitingMute Traveling out-of-range Using the page featureStoring phone numbers Chain dialing Making calls with memory dialing Memory dialingErasing a stored phone number When speaking on the base When speaking on the handsetWay conferencing Integrated answering device Turning the answering system on/off Setting up your answering systemPreset Message Setting your greetingRecording a personal outgoing message Greeting Choosing between the two outgoing messagesSelecting the message record time Announce only featureSelecting a PIN code Setting ring time switch Playing your messages Using your answering systemSkipping a message Repeating a messageVoice memo Deleting a messageDeleting individual messages Deleting all messagesRecording a conversation Command Function # then Repeat Remote access away from homeRemote room monitor Changing the digital security code Headset installation Installing the beltclipTo attach the beltclip To remove the beltclipBattery replacement and handling MaintenanceSymptom Suggestion TroubleshootingSymptom Suggestion At Uniden, we’ll take care of you K, L IndexW, X, Y, Z