Uniden EXS 2050 manual Remote access away from home, Command Function # then Repeat

Page 33

During the remote

operation, displays on the base.

You must enter a command within 15 seconds of entering the command waiting mode or the answering system automatically hangs up and returns to standby.

The system will only play back messages for four minutes and then it returns to the command waiting mode. To continue playing your message, press # then 2 again within 15 seconds

Remote access away from home

You can operate your answering system from a remote location using any touch-tone telephone. Use this function to check for recorded messages, to play or delete messages, to record a new outgoing message, and to monitor sounds in the room.

1 Call your telephone number.

2 While the greeting message plays, press # and your PIN code.

If the answering machine is off, let it ring 10 times until the greeting message plays.

Then, press # and your PIN code.

3 The answering system announces the time and day stamp and the number of messages stored in memory. Then the message playback automatically begins.

4 You may continue to listen to your message or you may select a command from the following chart.

Command

Function

# then 1

Repeat

#then 2 Playing your messages

#then 3 Skipping a message

#then 4 Deleting a message

#then 5 Stop message playback

#then 6 Answering system on

#then 7 Voice memo record/stop

(up to 4 minute recording time)

#then 8 Greeting message record/stop

#then 9 Answer system off

# then *

Room monitor

5 After all of your messages have played, or the playback time exceeds 4 minutes, you will hear intermittent tones indicating that the system is in the command waiting mode. You may enter another command at this time from the chart above.

6 When you finish, hang up to exit the system.

The answering system automatically returns to standby.

30

Page 32 Page 34
Image 33
Page 32 Page 34
Contents Page Introduction FeaturesTalk Flash Controls and functions43 44 45 Contents Read this first Base unitHandset Checking the package contents Choose the best location Setting up the base unitConnect the base unit If you want to install the base unit on the wall, seeIf your dialing system is Set the switch to Tone Choose the dialing modePulse If you arent sure of your dialing systemStandard wall plate mounting Mounting the base unit on a wallDirect wall plate mounting Use only Uniden Battery BT-905 supplied with your phone Installing the handset battery packWhen the battery charge becomes low Battery use time per chargeCleaning the charging contacts Do not use any liquids or solventsOther Operations Making a callFrom the handset Receiving a callFrom the base Ringer muteHandset ringer tone and volume Adjusting the volumeFlash and Call Waiting Redialing a callMute Traveling out-of-range Using the page featureStoring phone numbers Chain dialing Making calls with memory dialing Memory dialingErasing a stored phone number When speaking on the handset When speaking on the baseWay conferencing Integrated answering device Turning the answering system on/off Setting up your answering systemPreset Message Setting your greetingRecording a personal outgoing message Greeting Choosing between the two outgoing messagesAnnounce only feature Selecting the message record timeSelecting a PIN code Setting ring time switch Playing your messages Using your answering systemSkipping a message Repeating a messageVoice memo Deleting a messageDeleting individual messages Deleting all messagesRecording a conversation Command Function # then Repeat Remote access away from homeRemote room monitor Changing the digital security code Headset installation Installing the beltclipTo attach the beltclip To remove the beltclipBattery replacement and handling MaintenanceSymptom Suggestion TroubleshootingSymptom Suggestion At Uniden, we’ll take care of you Index K, LW, X, Y, Z
Top Page Image Contents