Uniden EXS 2050 manual Maintenance, Battery replacement and handling

Page 37

Note on power sources

Battery replacement and handling

When the operating time becomes short, even after the battery is recharged, please replace the battery.

With normal usage, your battery should last about one year.

Please contact your place of purchase for a replacement battery.

Power Failure

During the period that the power is off, you will not be able to make or receive calls with the telephone.

RECYCLING NICKEL- CADMIUM BATTERIES

NICKEL-

CADMIUM

BATTERIES

MUST BE

DISPOSED OF

Ni-CdPROPERLY.

Nickel-cadmium cells are used in the battery pack. Please take your used nickel- cadmium battery packs to a store that recycles nickel- cadmium batteries.

Caution

•Use the specified battery pack.

•Do not remove the battery from the handset to charge it.

•Never throw the battery into a fire, disassemble it, or heat it.

•Do not remove or damage the battery casing.

Maintenance

When slightly dirty

Wipe with a soft, dry cloth.

When very dirty

Wipe with a soft cloth that has been dampened with diluted, neutral detergent. Dry with a dry cloth.

When the charging terminals become dirty

Wipe with a dry cloth.

Caution

Do not use paint thinner, benzene, alcohol, or other chemical products. Doing so may discolor the surface of the telephone and damage the finish.

34

Image 37

Contents Page Introduction FeaturesTalk Flash Controls and functions43 44 45 Contents Base unit Read this firstHandset Checking the package contents Choose the best location Setting up the base unitConnect the base unit If you want to install the base unit on the wall, seeIf your dialing system is Set the switch to Tone Choose the dialing modePulse If you arent sure of your dialing systemStandard wall plate mounting Mounting the base unit on a wallDirect wall plate mounting Use only Uniden Battery BT-905 supplied with your phone Installing the handset battery packWhen the battery charge becomes low Battery use time per chargeCleaning the charging contacts Do not use any liquids or solventsOther Operations Making a callFrom the handset Receiving a callFrom the base Ringer muteHandset ringer tone and volume Adjusting the volumeRedialing a call Flash and Call WaitingMute Traveling out-of-range Using the page featureStoring phone numbers Chain dialing Making calls with memory dialing Memory dialingErasing a stored phone number When speaking on the base When speaking on the handsetWay conferencing Integrated answering device Turning the answering system on/off Setting up your answering systemPreset Message Setting your greetingRecording a personal outgoing message Greeting Choosing between the two outgoing messagesSelecting the message record time Announce only featureSelecting a PIN code Setting ring time switch Playing your messages Using your answering systemSkipping a message Repeating a messageVoice memo Deleting a messageDeleting individual messages Deleting all messagesRecording a conversation Command Function # then Repeat Remote access away from homeRemote room monitor Changing the digital security code Headset installation Installing the beltclipTo attach the beltclip To remove the beltclipBattery replacement and handling MaintenanceSymptom Suggestion TroubleshootingSymptom Suggestion At Uniden, we’ll take care of you K, L IndexW, X, Y, Z