Uniden EXS 2050 manual Changing the digital security code

Page 35

If the handset battery pack is completely discharged or the battery pack is removed, the digital security code will be lost. If this happens, a new security code is set automatically next time the battery pack is charged.

ADDITIONAL INFORMATION

Changing the digital security code

The digital security code is an identification code used to connect the handset and the base unit. Normally, setting the code is not necessary.

The first time you charge your handset, the security code is automatically set.

In the rare situation that you suspect another cordless telephone is using the same security code, you can change the code.

1 Remove the handset from the base unit. Press and hold page .

2 While the handset is emitting the paging sound, place the handset on the base unit holding page .

The paging tone stops.

Leave the handset on the base for more than 3 seconds. A random, new security code is set.

32

Image 35
Contents Page Introduction FeaturesTalk Flash Controls and functions43 44 45 Contents Handset Read this firstBase unit Checking the package contents Choose the best location Setting up the base unitConnect the base unit If you want to install the base unit on the wall, seeIf you arent sure of your dialing system Choose the dialing modeIf your dialing system is Set the switch to Tone PulseStandard wall plate mounting Mounting the base unit on a wallDirect wall plate mounting Use only Uniden Battery BT-905 supplied with your phone Installing the handset battery packDo not use any liquids or solvents Battery use time per chargeWhen the battery charge becomes low Cleaning the charging contactsOther Operations Making a callRinger mute Receiving a callFrom the handset From the baseHandset ringer tone and volume Adjusting the volumeMute Flash and Call WaitingRedialing a call Traveling out-of-range Using the page featureStoring phone numbers Chain dialing Making calls with memory dialing Memory dialingErasing a stored phone number Way conferencing When speaking on the handsetWhen speaking on the base Integrated answering device Turning the answering system on/off Setting up your answering systemChoosing between the two outgoing messages Setting your greetingPreset Message Recording a personal outgoing message GreetingSelecting a PIN code Announce only featureSelecting the message record time Setting ring time switch Playing your messages Using your answering systemSkipping a message Repeating a messageDeleting all messages Deleting a messageVoice memo Deleting individual messagesRecording a conversation Command Function # then Repeat Remote access away from homeRemote room monitor Changing the digital security code To remove the beltclip Installing the beltclipHeadset installation To attach the beltclipBattery replacement and handling MaintenanceSymptom Suggestion TroubleshootingSymptom Suggestion At Uniden, we’ll take care of you W, X, Y, Z IndexK, L