Connections, Setup recommendations | Philips CDR800 guide

xp CDR 800/17.1 eng. 25-07-2001 15:12 Pagina 11

Connections

Installation

23456

Connections

1connection to the power

2OPTICAL IN

connects to the digital optical output of an external digital source (CD player, DVD, DAT, etc.), so you can record from this source (AUX OPTICAL)

3DIGITAL IN

connects to the digital coaxial output of an external digital source (CD player, DVD, DAT, etc.), so you can record from this source (AUX DIGITAL)

4DIGITAL OUT

connects to the digital coaxial input of an ampliﬁer/receiver, so you can listen to playback of the set via the ampliﬁer/receiver

5ANALOG IN

connects to the line (analog) output of an ampliﬁer/receiver or other analog source (tape deck, tuner etc.), so you can record from this source (AUX ANALOG). For recording from a record player both recorder and record player should be connected to an ampliﬁer/receiver

6ANALOG OUT

connects to the line (analog) input of an ampliﬁer/receiver, so you can listen to playback of the set via the ampliﬁer/receiver

Setup recommendations

–Place the set on a solid, vibration free surface.

–Make sure there is sufﬁcient space around the set to prevent overheating.

–Do not place the set near a source of heat or in direct sunlight.

–Do not use the set under extremely damp conditions.

–If the set is placed in a cabinet, make sure that a 2.5 cm space remains free on all sides of the CD recorder for proper ventilation.

–Active mobile phones near to the set may cause malfunctions.

–Place the set below your receiver.

Connections general

NEVER MAKE OR CHANGE CONNECTIONS WITH THE POWER SWITCHED ON

For playback on both recorder deck and changer deck the set should be connected to your ampliﬁer/receiver. For this the following outputs are present:

–Digital coaxial output (DIGITAL OUT);

–Analog output (ANALOG OUT).

For external recording the following inputs are present:

–Digital optical input (OPTICAL IN);

–Digital coaxial input (DIGITAL IN);

–Analog input (ANALOG IN).

These inputs can be connected to the corresponding output(s) of your ampliﬁer/receiver or directly to the corresponding output(s) of the external source. Record players cannot be connected directly to the set.

The connections you make will depend upon the possibilities your audio equipment offers and how you are going to use the set. Please refer to the user manuals for your other audio equipment ﬁrst.

Digital recordings (optical or coaxial) give the best performance in audio and usability.

If possible, always make both digital and analog connections. In this way you can always make analog recordings when digital recording is not possible.

English