Philips CDR800 manual Troubleshooting, Will invalidate the guarantee, Laser safety

xp CDR 800/17.1 eng. 25-07-2001 15:12 Pagina 27

Troubleshooting

	WARNING
	Under no circumstances should you try to repair the set yourself as this
	will invalidate the guarantee.
	Do not open the set as there is a risk of electric shock.
	If a fault occurs, first check the points listed, before taking the set for
	repair. If you are unable to solve a problem by following these hints,
	consult your dealer or service center.
	Laser safety
	This unit employs a laser. Only a qualified service person should remove
	the cover or attempt to service this device, due to possible eye injury.
Problem	Solution:
No power	– ensure that the ON/OFF button is on: the set is in standby mode, press any key to
	activate it
	– ensure that the power cord is plugged in correctly
No sound	– check the audio connections
	– try using a different source on the amplifier
Remote control does not work	– first select the right source on the remote control
	– point the remote control directly at the set
Will not record	– clean the disc
	– check if CDR(W) is an unfinalized disc
	– check that the disc is recordable and replace if necessary
	– the disc is not an AUDIO disc (WRONG DISC)
Recording is distorted	– make sure the recording level is correct
Recorded tracks do not start or stop	– try another auto track setting
at the correct time or tracks have been	– check if there are at least 2.7 seconds silence in between the tracks
merged together	(analog recording only)
	– insert track increments manually with the remote control
20 second pause between recordings	– see “Recording with automatic start“
Recorded disc does not play	– finalize the CDR(W)
in other standard CD player	– insert the CDRW in a CDRW compatible player
Stops during recording	– use Philips audio CDR(W)s
	– in case recording process is interrupted (power loss, mechanical shock), start
	recording again with a new disc
Missing directories on MP3-CD	– only albums with playable files will be shown
INSERT DISC indication	– replace or clean the disc
	– insert a CD(RW), label upwards
	– wait until the lens has cleared
USE AUDIO CD indication	– insert a digital audio disc marked with “Digital audio” and the special logo
CHECK INPUT indication	– select the correct input
	– make sure the digital source is switched on
	– make sure the connection cord is properly connected
Unexpected start of Demo mode	– Keep STOP 9 on the set pressed for at least 5 seconds to cancel Demo
(automatic display of recorder features)	mode permanently
Set does not react	– unplug the set, then replug it

English

27