AZ 1065 /17 page 17
TROUBLESHOOTING
If a fault occurs, first check the points listed below before taking the set for repair.
If you are unable to remedy a problem by following these hints, consult your dealer or service center.
WARNING: Do not open the set as there is a risk of electric shock. Under no circumstances should you try to repair the set yourself, as this will invalidate the warranty.
English
PROBLEM
–POSSIBLE CAUSE
• REMEDY
No sound/power
–VOLUME not adjusted
• Adjust the VOLUME
–Headphones connected
• Disconnect headphones
–Power cord not securely connected
• Connect the power cord properly
–Batteries dead/ incorrectly inserted
• Insert (fresh) batteries correctly
indication
–
• Use a finalized
–CD badly scratched or dirty
• Replace/ clean CD, see Maintenance
The CD skips tracks
–CD is damaged or dirty
• Replace or clean the CD
–SHUFFLE or PROGRAM is active
• Quit SHUFFLE/PROGRAM mode(s)
Poor cassette sound quality
Severe radio hum or noise
–Electrical interference: set too close to TV,
VCR or computer
• Increase the distance
Poor radio reception
–Weak radio signal
•FM: Direct the FM telescopic antenna for optimum reception
•AM: Turn the set for optimum reception
or 
indication
–No CD inserted
• Insert a CD
–CD badly scratched or dirty
• Replace/ clean CD, see Maintenance
–Laser lens steamed up,
• Wait until lens has cleared
– Dust and dirt on the heads, etc.
• Clean deck parts etc., see maintenance
– Use of incompatible cassette types (METAL or CHROME).
• Only use NORMAL (IEC I) for recording.
Recording does not work
– Cassette tab(s) may be broken
•Apply a piece of adhesive tape over the missing tab space.
Remote control does not function properly
–Batteries dead/ incorrectly inserted
• Insert (fresh) batteries correctly
–Distance/ angle between the set too large
• Reduce the distance/ angle
The type plate is located on the bottom of the set.
17