Selecting a source
System
When not playing, the digital loudspeakers should be left in the standby state. This uses a negligible amount of electricity, but ensures that the components of the loudspeakers operate at maximum efficiency from the moment you start.
If you are not going to use the digital loudspeakers for several days you should switch each unit completely off at the back panel, and disconnect it from the AC power supply.
To switch to standby
●Press Off on the remote.
The loudspeakers will switch to standby and the back panel indicator on each speaker will dim.
Using the DSP33 Digital Loudspeaker
To select a source
●Press the appropriate source key on the remote; eg DVD.
This will bring the digital loudspeakers out of standby, and the
As standard, all the sources are set to select the D1 digital input of the DSP33. To select the D2 input, see To configure the source options, page 31.
20