Meridian America Guide to Configuring Your DSP33 Loudspeakers for Enhanced Audio Quality

Page 35

Configuring the DSP33 loudspeakers using a computer

For best results with a Meridian D1500 or D2500 subwoofer choose Free, Boundary, or Corner as appropriate.

If you have specified the Speaker Use as Centre you can apply a Centre Speaker tilt offset, which is added to the Tilt value for the selected source.

The recommended setting is -1dB when the speaker is positioned above a television.

Start volume

The Start volume setting determines the volume selected on coming out of standby.

●Set the Start volume to 65 to leave the volume unchanged (as on other Meridian products).

●Set the Start volume to a value other than 65 to set the volume to that value.

Advanced options

The Advanced options are described in the following table:

Option	What it means
Volume control	Specifies whether the DSP33
	provides volume control for the
	system. Choose Main if the DSP33 is
	in the main room, Secondary if the
	DSP33 is used in a second room, or
	None if the DSP33 is in the second or
	third room of a three-room system.
Comms controller	Specifies whether the DSP33 is
status	controller, not controller, or set
	automatically.
System address	For multi-room setups.

30

Image 35

Contents Meridian DSP33 Digital Loudspeaker System Meridian DSP33 Digital Loudspeaker System User Guide Sales and service in the UK Contents Troubleshooting Configuring the DSP33 Loudspeakers using a ComputerIntroduction DSP33 drivers Digital Signal ProcessingDSP33 Digital Loudspeaker System Mounting options Power amplifiersMeridian High Resolution MHR CabinetMeridian Comms Meridian Digital Compact Theatre Sample configurationsOther applications DSP33 Digital Loudspeaker SystemSpecification Specification and accessoriesAvailable accessories Setting up the DSP33 Digital Loudspeaker System Radio interference UnpackingTo avoid overheating Safety warningsPositioning the digital loudspeakers To position the digital loudspeakersTo wall mount the digital loudspeakers To obtain the best soundBack panel Connecting the loudspeakersTo reset the configuration of the digital loudspeaker Communications connections Digital connectionsTo use a DSP33 loudspeaker as a centre speaker Connecting the digital loudspeakersTo connect two DSP33 loudspeakers in a Meridian system Digital Loudspeaker System Loudspeaker System To use the DSP33 as a multimedia speaker with a PC Using the DSP33 Digital Loudspeaker System To select a source To switch to standbySelecting a source Adjusting the volume To change the balance Adjusting the balance or phaseTo reset the balance to the centre To change the phaseConfiguring the DSP33 loudspeakers using a computer Requirements Meridian Configuration programTo install the Meridian Configuration program Program Running the Meridian Configuration programTo connect the serial cable To select which loudspeaker to configureCreating a new settings file To display or edit the settings To display the settingsTo change the setup options Changing the setup optionsStart volume To configure the source options Setting up sourcesTo set up sources Loudspeakers using Advanced To store the settings to the DSP33 loudspeaker Completing the configurationTo save the current settings Troubleshooting Troubleshooting Unit stays in standby light is dim Configuring the DSP33 does not have any effectGreen indicator on back panel is flashing Centre not workingSound is odd or mono Only the master loudspeaker playsGuarantee Service and guaranteeService Troubleshooting Index Index