Sony TCD-D8 To eject the cassette, To protect your recording, To prevent accidental operations

Notes

•Make sure that the cassette compartment lid is closed and

“ ” or

“ ” is not displayed before disconnecting the AC power adaptor or removing the batteries. Otherwise, the cassette compartment lid may not close. In this case, connect the power adaptor or insert the batteries again.

•Press and hold the button in the center of the HOLD/PUSH OPEN switch when sliding it to OPEN.

Tip

While the tape-corder is in the stop mode, slide the

HOLD/PUSH OPEN switch to HOLD to enter the low-power consumption mode manually. (See page 26.)

To eject the cassette

While the tape-corder is in the stop mode, press the HOLD/PUSH OPEN switch and slide to OPEN.

Press and slide.

To protect your recording

Slide open the record-protect shutter to record-protect your tape.

If the shutter is open, you cannot record on the tape.

If the shutter is closed, you can record on the tape.

Notes on DAT cassettes

•Unlike conventional analog cassettes, playback and recording are applicable on one side of the cassette only.

•Under normal usage, the construction of the DAT cassette prevents undesirable entry of dust and foreign particles. Do not open the DAT cassette unnecessarily.

•Do not insert items into the holes on the reverse side of the DAT cassette.

To prevent accidental operations

Slide the HOLD/PUSH OPEN switch to HOLD.

Inserting the Cassette

Inserting the Cassette

7EN