Ericsson LBI-38823C manual Battery Packs FM Approved, Installing the Battery Pack

Page 19

BATTERY PACKS

The following battery pack are available for use with the Dual Format PCS™ radio:

PCPA1J	Rechargeable Battery Pack, High Capacity
(19A705293P1)
PCPA1K	Rechargeable Battery Pack, Extra High Capacity
(19A705293P2)

BATTERY PACKS (FM APPROVED)

Only battery packs identified with a green latch shall be used with a portable radio that is rated and labeled as Factory Mutual Intrinsically Safe. Use of nonspecified battery packs voids Factory Mutual approval. The following battery pack option is approved for use in intrinsically safe radios.

PCPA1L	Rechargeable Battery Pack
	Extra High Capacity (Tall Case)

CAUTION

Battery packs used with the PCS radio must be supplied by Ericsson Inc.

INSTALLING THE BATTERY PACK

1.Ensure the ON/OFF switch on the battery pack is in the off position.

2.Hold the radio and battery pack with the back of them facing you. See Figure 7.

3.Align the grooves on the top of the battery pack with the grooves on the bottom of the radio.

4.Slide the battery pack fully into the radio until the battery release latch clicks into place.

19

Image 19

Contents Ericssonz Page Table of Contents Scan Operation Introduction Dual Format PCS Radio Scan Model Dual Format PCS Radio System Model PTT Button SwitchDescription Controls ON/OFFScan Model Keypad STO HOME/ESPC SCAN-A/DLock IndicatorsRCL Status Indicators System And Group/Channel IndicatorsBSY SCN Turn onAlert Tones Standard Tones Power-UpLow Battery Carrier Control TimerSystem Busy Call ReceivedCall Queued Edacs Only Autokey Edacs OnlyOut Of Range/System Inoperative Error MessagesIntrinsically Safe Usage Option # Description Options and AccessoriesPictured on Options And Accessories Battery Packs FM Approved Battery PacksInstalling the Battery Pack Charging the Battery Packs Removing the Battery PackInstalling the Battery Pack Swivel Mount Removal and Replacement Rechargeable Battery Pack DisposalSwivel Mount Removal And Replacement Operating Tips Operating ProceduresPage NICKEL-CADMIUM Battery Warranty Receiving a Message Edacs OperationSending a Message Squelch AdjustmentScan Model Radio Sending a Special CallSending a Manually Entered Individual Call System Model RadioPage Sending a Manually Entered Interconnect Call Storing Individual And Interconnect Numbers Enter the desired storage location number Edacs Special Call Flowchart Wide Area And Priority System Scanning Optional Enable/Disable ScanScan Operation Add/Delete GroupsDtmf Overdial Dynamic Regrouping OptionalEmergency Operation Optional Receiving An Emergency Call HOME/EMERGENCY KEY DefinitionSending An Emergency Call Keypad Lock System Model Only HomeThis page intentionally left blank GE-MARC Operation Sending a Message Scan Model Radio Sending a Preprogrammed Special Call In Conference Call Sending a Manually Entered Individual Call Sending a Manually Entered Interconnect Call Page Storing Individual And Interconnect Numbers Page Number will be displayed GE-MARC Special Call Flowchart Wide Area System Scan Direct ModeReceiving a Message Sending a Message Add/Delete Channels Sending a Manually Entered Interconnect CallScan must be disabled to add a channel to the scan list This page intentionally left blank Conventional Mode Operation Sending a Message After all the digits have been keyed in, release the PTT bar To delete Channels from the scan list Frequency Band OPERATOR’S Name Emergency Group Radio TypeSystem System Number Name TRK/CNV GRP/CHN GRP/CHN USE Warranty Emergency Numbers