Ericsson LBI-38823C manual Sending a Message

Page 58

SENDING A MESSAGE

1.Turn the radio on and set the desired System and Channel as described in the previous section.

2.Ensure no one is transmitting on the selected channel by pressing the SHIFT/CLR button twice ("double click") and/or observing the display for the absence of the "BSY" indicator to ensure that no one is transmitting on the selected Channel.

3.Holding the radio about 3 inches from your mouth, press the PTT bar and speak as you would normally into the microphone.

4.Release the PTT bar when the transmission is complete and listen for any reply.

SQUELCH ADJUSTMENT

In normal operation the squelch is automatically set by the radio and does not need adjusting. If it becomes necessary to adjust the squelch, the squelch may be adjusted using the following procedure:

NOTE

The radio must be on a Conventional System or an EDACS working Channel (i.e. receiving a voice call) to adjust the squelch. It is recommended to adjust squelch from a Conventional System.

1.Press and hold the SHFT/CLR button.

2.Use the VOLUME s or t buttons to adjust the squelch. Pressing the VOLUME s will open the squelch and pressing the VOLUME t will close the squelch.

SENDING A MANUALLY ENTERED INTERCONNECT CALL

1.Select a channel in your radio system that has telephone interconnect capability. The radio should be programmed for DTMF operation on this channel.

58

Image 58

Contents Ericssonz Page Table of Contents Scan Operation Introduction Dual Format PCS Radio Scan Model Dual Format PCS Radio System Model Controls ON/OFF SwitchDescription PTT ButtonScan Model Keypad SCAN-A/D HOME/ESPC STOLock IndicatorsRCL Status Indicators System And Group/Channel IndicatorsBSY Turn on SCNCarrier Control Timer Standard Tones Power-UpLow Battery Alert TonesAutokey Edacs Only Call ReceivedCall Queued Edacs Only System BusyOut Of Range/System Inoperative Error MessagesIntrinsically Safe Usage Option # Description Options and AccessoriesPictured on Options And Accessories Battery Packs FM Approved Battery PacksInstalling the Battery Pack Removing the Battery Pack Charging the Battery PacksInstalling the Battery Pack Rechargeable Battery Pack Disposal Swivel Mount Removal and ReplacementSwivel Mount Removal And Replacement Operating Procedures Operating TipsPage NICKEL-CADMIUM Battery Warranty Edacs Operation Receiving a MessageSquelch Adjustment Sending a MessageSending a Special Call Scan Model RadioSystem Model Radio Sending a Manually Entered Individual CallPage Sending a Manually Entered Interconnect Call Storing Individual And Interconnect Numbers Enter the desired storage location number Edacs Special Call Flowchart Add/Delete Groups Enable/Disable ScanScan Operation Wide Area And Priority System Scanning OptionalDynamic Regrouping Optional Dtmf OverdialEmergency Operation Optional Receiving An Emergency Call HOME/EMERGENCY KEY DefinitionSending An Emergency Call Home Keypad Lock System Model OnlyThis page intentionally left blank GE-MARC Operation Sending a Message Scan Model Radio Sending a Preprogrammed Special Call In Conference Call Sending a Manually Entered Individual Call Sending a Manually Entered Interconnect Call Page Storing Individual And Interconnect Numbers Page Number will be displayed GE-MARC Special Call Flowchart Wide Area System Scan Direct ModeReceiving a Message Sending a Message Sending a Manually Entered Interconnect Call Add/Delete ChannelsScan must be disabled to add a channel to the scan list This page intentionally left blank Conventional Mode Operation Sending a Message After all the digits have been keyed in, release the PTT bar To delete Channels from the scan list Radio Type Frequency Band OPERATOR’S Name Emergency GroupSystem System Number Name TRK/CNV GRP/CHN GRP/CHN USE Warranty Emergency Numbers