Ericsson LBI-38823C manual Dynamic Regrouping Optional, Dtmf Overdial

Page 37

channel is found, the radio will switch to the new system and sound an alert tone. Group selection may change upon switching to the new system.

The radio may also be programmed for priority wide area system scan. A priority system may be assigned to each system programmed into the radio. Radios programmed in this manner will scan the priority trunked system’s control channel once every one, two, three or four minutes (programmable). This priority scan timer is reset each time the PTT bar is pressed.

DYNAMIC REGROUPING (Optional)

Dynamic Regrouping is a feature which allows the System Manager to dynamically program new groups into selected radios. Upon development of the regrouping plan, the site controller sends each radio the regroup plan number, "group position", and activate/deactivate commands. When the radio is regrouped, it will alert the user and the Group field will will display the regroup number "nn" (nn = 01-08).

NOTE

The regroup is identified by the leading zero in the 10’s digit of the Group field. This zero is normally surpressed in Groups 1-8.

DTMF OVERDIAL

After the radio has acquired a working channel to make a message trunked call, DTMF tones can be sent by:

1.Pressing and holding the PTT bar.

2.Manually entering the desired numbers from the keypad.

In the same manner, stored interconnect numbers (tones) may be sent by:

1.Recalling the desired storage location as described previously in the

Recalling Manually Stored Individual and Interconnect Numbers section.

2.Pressing the PTT bar to send the tones.

37

Image 37

Contents Ericssonz Page Table of Contents Scan Operation Introduction Dual Format PCS Radio Scan Model Dual Format PCS Radio System Model Description SwitchControls ON/OFF PTT ButtonScan Model Keypad SPC HOME/ESCAN-A/D STOLock IndicatorsRCL Status Indicators System And Group/Channel IndicatorsBSY SCN Turn onLow Battery Standard Tones Power-UpCarrier Control Timer Alert TonesCall Queued Edacs Only Call ReceivedAutokey Edacs Only System BusyOut Of Range/System Inoperative Error MessagesIntrinsically Safe Usage Option # Description Options and AccessoriesPictured on Options And Accessories Battery Packs FM Approved Battery PacksInstalling the Battery Pack Charging the Battery Packs Removing the Battery PackInstalling the Battery Pack Swivel Mount Removal and Replacement Rechargeable Battery Pack DisposalSwivel Mount Removal And Replacement Operating Tips Operating ProceduresPage NICKEL-CADMIUM Battery Warranty Receiving a Message Edacs OperationSending a Message Squelch AdjustmentScan Model Radio Sending a Special CallSending a Manually Entered Individual Call System Model RadioPage Sending a Manually Entered Interconnect Call Storing Individual And Interconnect Numbers Enter the desired storage location number Edacs Special Call Flowchart Scan Operation Enable/Disable ScanAdd/Delete Groups Wide Area And Priority System Scanning OptionalDtmf Overdial Dynamic Regrouping OptionalEmergency Operation Optional Receiving An Emergency Call HOME/EMERGENCY KEY DefinitionSending An Emergency Call Keypad Lock System Model Only HomeThis page intentionally left blank GE-MARC Operation Sending a Message Scan Model Radio Sending a Preprogrammed Special Call In Conference Call Sending a Manually Entered Individual Call Sending a Manually Entered Interconnect Call Page Storing Individual And Interconnect Numbers Page Number will be displayed GE-MARC Special Call Flowchart Wide Area System Scan Direct ModeReceiving a Message Sending a Message Add/Delete Channels Sending a Manually Entered Interconnect CallScan must be disabled to add a channel to the scan list This page intentionally left blank Conventional Mode Operation Sending a Message After all the digits have been keyed in, release the PTT bar To delete Channels from the scan list Frequency Band OPERATOR’S Name Emergency Group Radio TypeSystem System Number Name TRK/CNV GRP/CHN GRP/CHN USE Warranty Emergency Numbers