Ericsson LBI-38823C manual Sending a Message, Squelch Adjustment

Page 28

5.Using the VOLUME buttons, adjust the volume as necessary.

SENDING A MESSAGE

1.Turn the radio on and set the desired System and Group as described under RECEIVE A MESSAGE steps 1-3.

2.Observe the display for the presence of the "SV" flag for service and the absence of the "BSY" indicator to ensure that no one is transmitting on the selected Group.

3.Press and hold the PTT bar. The radio will perform the necessary signalling required to obtain a communication channel. If the signalling is unsuccessful, the radio will sound the appropriate alert tone(s).

4.When the channel has been acquired, the "TX" and "BSY" flags are illuminated and if programmed, the Call Originate tone will sound.

5.Hold the radio about 3 inches from your mouth and speak as you would normally into the microphone.

6.Release the PTT bar when the transmission is complete and listen for any reply.

SQUELCH ADJUSTMENT

In normal operation the squelch is automatically set by the radio and does not need adjusting. If it becomes necessary to adjust the squelch, the squelch may be adjusted using the following procedure:

NOTE

The radio must be on a Conventional System or an EDACS working Channel (i.e. receiving a voice call) to adjust the squelch. It is recommended to adjust squelch from a Conventional System.

28

Image 28

Contents Ericssonz Page Table of Contents Scan Operation Introduction Dual Format PCS Radio Scan Model Dual Format PCS Radio System Model Switch DescriptionControls ON/OFF PTT ButtonScan Model Keypad HOME/E SPCSCAN-A/D STOLock IndicatorsRCL Status Indicators System And Group/Channel IndicatorsBSY Turn on SCNStandard Tones Power-Up Low BatteryCarrier Control Timer Alert TonesCall Received Call Queued Edacs OnlyAutokey Edacs Only System BusyOut Of Range/System Inoperative Error MessagesIntrinsically Safe Usage Option # Description Options and AccessoriesPictured on Options And Accessories Battery Packs FM Approved Battery PacksInstalling the Battery Pack Removing the Battery Pack Charging the Battery PacksInstalling the Battery Pack Rechargeable Battery Pack Disposal Swivel Mount Removal and ReplacementSwivel Mount Removal And Replacement Operating Procedures Operating TipsPage NICKEL-CADMIUM Battery Warranty Edacs Operation Receiving a MessageSquelch Adjustment Sending a MessageSending a Special Call Scan Model RadioSystem Model Radio Sending a Manually Entered Individual CallPage Sending a Manually Entered Interconnect Call Storing Individual And Interconnect Numbers Enter the desired storage location number Edacs Special Call Flowchart Enable/Disable Scan Scan OperationAdd/Delete Groups Wide Area And Priority System Scanning OptionalDynamic Regrouping Optional Dtmf OverdialEmergency Operation Optional Receiving An Emergency Call HOME/EMERGENCY KEY DefinitionSending An Emergency Call Home Keypad Lock System Model OnlyThis page intentionally left blank GE-MARC Operation Sending a Message Scan Model Radio Sending a Preprogrammed Special Call In Conference Call Sending a Manually Entered Individual Call Sending a Manually Entered Interconnect Call Page Storing Individual And Interconnect Numbers Page Number will be displayed GE-MARC Special Call Flowchart Wide Area System Scan Direct ModeReceiving a Message Sending a Message Sending a Manually Entered Interconnect Call Add/Delete ChannelsScan must be disabled to add a channel to the scan list This page intentionally left blank Conventional Mode Operation Sending a Message After all the digits have been keyed in, release the PTT bar To delete Channels from the scan list Radio Type Frequency Band OPERATOR’S Name Emergency GroupSystem System Number Name TRK/CNV GRP/CHN GRP/CHN USE Warranty Emergency Numbers