Ericsson LBI-38823C manual Operating Tips, Operating Procedures

Page 24

OPERATING TIPS

The following conditions tend to reduce the effective range of two-way radios and should be avoided whenever possible.

Operating the radio in low terrain areas or while under power lines or bridges.

Operating the radio inside of a vehicle or inside metal or steel framed building unless using an outside antenna.

Obstructions such as mountains or buildings between the person sending and the person receiving the message.

In areas where transmission or reception is poor, some improvements may be obtained by insuring that the antenna is vertical. Moving a few yards in another direction or moving to a higher elevation may also improve communication.

OPERATING PROCEDURES

Two-way FM radio systems must be operated in accordance with the rules and regulations of the Federal Communications Commission (FCC). As an operator of two-way radio equipment, you must be thoroughly familiar with the rules that apply to your particular type of radio operation. Following these rules will help eliminate confusion and will assure the most efficient use of existing radio channels. This will provide a smooth operating radio network.

When using two-way radios, remember the following rules:

1.It is a violation of FCC rules to interrupt any distress or emergency messages. As the radio operates in much the same way as a tele- phone "party line", always listen and/or observe the absence of the "BSY" flag to make sure that the line is clear. If someone is sending an emergency message, such as reporting a fire or asking for help in an accident; KEEP OFF THE AIR! Emergency calls have priority over all other messages.

2.Use of profane or obscene language is prohibited by federal law.

24

Image 24
Contents Ericssonz Page Table of Contents Scan Operation Introduction Dual Format PCS Radio Scan Model Dual Format PCS Radio System Model Switch DescriptionControls ON/OFF PTT ButtonScan Model Keypad HOME/E SPCSCAN-A/D STOIndicators LockRCL System And Group/Channel Indicators Status IndicatorsBSY Turn on SCNStandard Tones Power-Up Low BatteryCarrier Control Timer Alert TonesCall Received Call Queued Edacs OnlyAutokey Edacs Only System BusyError Messages Out Of Range/System InoperativeIntrinsically Safe Usage Options and Accessories Option # DescriptionPictured on Options And Accessories Battery Packs Battery Packs FM ApprovedInstalling the Battery Pack Removing the Battery Pack Charging the Battery PacksInstalling the Battery Pack Rechargeable Battery Pack Disposal Swivel Mount Removal and ReplacementSwivel Mount Removal And Replacement Operating Procedures Operating TipsPage NICKEL-CADMIUM Battery Warranty Edacs Operation Receiving a MessageSquelch Adjustment Sending a MessageSending a Special Call Scan Model RadioSystem Model Radio Sending a Manually Entered Individual CallPage Sending a Manually Entered Interconnect Call Storing Individual And Interconnect Numbers Enter the desired storage location number Edacs Special Call Flowchart Enable/Disable Scan Scan OperationAdd/Delete Groups Wide Area And Priority System Scanning OptionalDynamic Regrouping Optional Dtmf OverdialHOME/EMERGENCY KEY Definition Emergency Operation Optional Receiving An Emergency CallSending An Emergency Call Home Keypad Lock System Model OnlyThis page intentionally left blank GE-MARC Operation Sending a Message Scan Model Radio Sending a Preprogrammed Special Call In Conference Call Sending a Manually Entered Individual Call Sending a Manually Entered Interconnect Call Page Storing Individual And Interconnect Numbers Page Number will be displayed GE-MARC Special Call Flowchart Direct Mode Wide Area System ScanReceiving a Message Sending a Message Sending a Manually Entered Interconnect Call Add/Delete ChannelsScan must be disabled to add a channel to the scan list This page intentionally left blank Conventional Mode Operation Sending a Message After all the digits have been keyed in, release the PTT bar To delete Channels from the scan list Radio Type Frequency Band OPERATOR’S Name Emergency GroupSystem System Number Name TRK/CNV GRP/CHN GRP/CHN USE Warranty Emergency Numbers