Craftsman 919.19541 owner manual Contents of Carton, Tools Required for Assembly, Unpacking

ASSEMBLY

Contents of Carton

1 -	Air Compressor
2 -	Wheels
2 -	Shoulder Bolts, 3/8-16
2 -	Hex Nuts, 3/8-16
1 -	Handle
1 -	Handle Grip
2 -	Cap Screws
2 -	1/4-20 Hex Nuts
2 -	Retainer Clips
2 -	Flat Washers
2 -	Rubber Bumpers
2 -	Screws, 1/4-20 x .75

Tools Required for Assembly

1 - 9/16” socket or open end wrench

1 - 1/2” socket or open end wrench

3.Slowly push the open ends of the handle onto both tabs at the same time. Continue pushing the handle into the saddle until the holes on the side of the saddle and handle are in line.

Unpacking

Remove unit from carton and discard all packaging. NOTE: Save all parts bags.

To Install Handle

The wheels and handle do not pro-

vide adequate clearance, stability, or support for pulling the unit up and down stairs or steps. The unit must be lifted or pushed up a ramp. Do not lift the unit by the manifold assembly; the unit could be damaged.

1.To make installation easier, sub- merge handle grip into warm soapy water. Remove handle grip from soapy water and slide onto handle.

2.Insert the open ends of the han- dle under the saddle. Before attaching handle, you may have to pull the open ends of the han- dle apart so they fit tightly against the side of the saddle. Looking in from the open end of the saddle, position the handle toward the two bent tabs, on the inside walls of the saddle.

4.Guide the straight end of each retaining clip through the saddle hole and both handle holes.

D24910 10- ENG