Craftsman 919.19541 owner manual Before Each Start-Up, How to Start

Page 16

6.After 20 minutes, close the drain valve (clockwise). The air receiver will fill to “cut-out” pressure and the motor will stop.

The compressor is now ready for use.

Before Each Start-Up:

1.Place On/Auto/Off lever to “OFF”.

2.Pull regulator knob out, turn counterclockwise until it stops. Push knob in to lock in place.

3.Attach hose and accessories. NOTE: The hose or accessory will require a quick connect plug if the air outlet is equipped with a quick connect.

Too much air pres- sure causes a haz- ardous risk of bursting. Check the

manufacturer’s maximum pressure rating for air tools and accessories. The regulator outlet pressure must never exceed the maximum pres- sure rating.

How to Start:

1.Turn the On/Auto/Off lever to “AUTO” and allow tank pressure to build. Motor will stop when tank pressure reaches “cut-out” pressure.

2.Pull the regulator knob out and turn clockwise to increase pres- sure. When the desired pressure is reached push knob in to lock in place. The compressor is ready for use.

NOTE: Always operate the air com- pressor in well-ventilated areas free of gasoline or other combustible vapors. If the compressor is being used to operate a sprayer DO NOT place near the spray area.

D24910

16- ENG

Image 16

Contents AIR Compressor Sears, Roebuck and Co., Hoffman Estates, IL 60179 U.S.ATable of Contents Safety Guidelines Definitions Specification TableImportant Safety Instructions Hazard What Could HappenAttachments & Accessories Hazard Never operate the compressor with Belt can cause serious injury if theyFire, Inhalation, Damage to Vehicle Surfaces Accessories AccessoriesGlossary Duty CycleAssembly Contents of CartonTools Required for Assembly To Install HandleAssemble Rubber Feet To Assemble WheelsTo Add Oil To Pump Installation To Add OilAir Compressor Location Before removing the oil fill cap or oil drain plugExtension Cords Voltage and Circuit ProtectionOperation Know Your Air CompressorHow to Use Your Unit How to Stop Before First Start-upBreak-in Instructions Pressure Release Valve Check ValveHow to Start Before Each Start-UpMaintenance Customer ResponsibilitiesTo Check Safety Valve To Drain TankOil ChangingMotor Pulley/Flywheel Alignment Air Filter Inspection ReplacementAir Compressor Pump Intake and Exhaust Valves Service and Adjustments To Replace or Clean Check ValveOutlet Tube Pressure Relief Tube Nuts Nuts Check Valve Screwdriver Open position nothing is visibleMotor Pressure Switch ReplacementTo Replace Regulator Regulator Arrow To Replace BeltWing Nut Storage Troubleshooting Problem Cause CorrectionPressure reading Minal box area Problem Cause Correction Contenido GarantíaDefiniciones DE Normas DE Seguridad Modelo Nº 919-195410Resultar en lesiones menores o ModeradasInstrucciones Importantes DE Seguridad Guarde Estas InstruccionesAgregados Y Accesorios Tros de acuerdo a los códigos eléctricos Advertencia Riesgo DE Quemaduras ¿QUÉ Puede OCURRIR? Advertencia Riesgo DE Operación Insegura ¿QUÉ Puede OCURRIR? Glosario AccesoriosCiclo DE Servicio AccesoriosEnsamblado Contenido de la cajaHerramientas necesarias para el ensamble DesempaqueEnsamble de las ruedas Ensamble de las patas de cauchoPara agregar aceite a la bomba TuercaInstalación Para agregar aceiteUbicación del compresor de aire EnchufeCables de extensión eléctrica Protección del voltaje y del circuitoOperación Conozca su compresor de aireCómo utilizar su unidad Antes del primer arranqueInstrucciones para el asentamiento Cómo detenerlaAntes de cada puesta en marcha Cómo poner en marchaMantenimiento Responsabilidades del clienteCómo verificar la válvula de seguridad AceiteCómo drenar el tanque VerificaciónFiltro de Aire Inspección y reemplazo Polea y volante AlineaciónServicio Y Ajustes Para reemplazar o limpiar la válvu La de retenciónTubo de salida Tuercas TuercasVálvula reguladoraMotor Para volver a arrancarPara reemplazar el regulador Interruptor de presión ReemplazoRegulador Flecha Cambio de la correaTuerca mariposa Almacenaje Guía DE Diagnóstico DE Problemas Problema Causa CorrecciónOperación. Nota Ajuste la presión Retire y limpie, o reemplace 57- SP D24910 D24910 58- SP 59- SP D24910 Get it fixed, at your home or ours