Xantrex Technology 806-1054-01 Common Problems, Buzz in Audio Equipment, Television Reception

Page 48

Freedom HF InvChg Owners Guide.book Page 34 Tuesday, April 29, 2014 12:10 PM

Common Problems

Buzz in Audio Equipment

Some inexpensive stereo systems may emit a buzzing noise from their loudspeakers when operated from the Freedom HF. This occurs because the power supply in the audio system does not adequately filter the modified sine wave produced by the inverter. The only solution is to use a sound system that has a higher quality power supply.

3.Keep the cables between the battery and the Freedom HF as short as possible, and twist them together with two to three twists per foot. (This minimizes radiated interference from the cables.)

4.Move the television as far away from the Freedom HF as possible.

5.Do not operate high power loads with the Freedom HF while the television is on.

Television Reception

When the Freedom HF is operating, it can interfere with television reception on some channels. If interference occurs, try the following:

1.Make sure that the chassis ground stud on the Freedom HF is solidly connected to the ground system of your vehicle or vessel.

2.Make sure that the television antenna provides an adequate (“snow-free”) signal, and that you are using good quality cable between the antenna and the television.

34

Freedom HF Owner’s Guide

Image 48
Contents Freedom HF Inverter/Chargers Page Exclusion for Documentation Document Part NumberDate and Revision Product NumbersAbout This Guide PurposeConventions Used ScopeRelated Information Important Safety Instructions Electrical Shock HazardFire and Burn Hazard Precautions When Working With Batteries Exposure to Chemicals and Gases Hazard Precautions for Using Rechargeable Appliances RegulatoryFCC Information to the User KKK Information to the UserPage Contents Page Introduction Materials ListKey Features Model Low Mid HighFeatures Default Setting Your SettingFeature Description Front Panel Freedom HF 1000, 1055, 1500Front Panel Freedom HF 1800 T Front Panel Freedom HF 1055 EMS,1800 EMSSerial number of your unit Display Panel All Models Remote and Power Module Panel Freedom HF 1055 EMS,1800 EMSSide Panel All Models Freedom Inverter/Charger Configuration Setting Battery Types on the Main UnitBattery Dip Switch Bulk Float Setting Absorption Switch 1SwitchViewing Inverter/Charger Information Adjusting Feature Settings ScreenTo change the charger’s charging current setting To change the inverter mode setting To adjust the low battery shutdown setting Freedom Inverter/Charger Operation Display Panel OperationFreedom Inverter/Charger Operation Operating in Shore Power Mode Operating in Inverter ModeInverter Mode Setting is on Standby Inverter Mode Setting is OFF Energy Saver 25-hour Automatic Shut OffaStatus LED During Inverter Mode LEDChecking Battery Status Checking Output PowerTurning the Audible Alarm on or OFF Operating Several Loads at OnceTransitioning from Shore Power to Inverter Mode Transitioning from Inverter Mode to Shore PowerPower Output Operating LimitsInput Voltage Operating Voltage Range Comment Condition Freedom HF Only Over-temperature Conditions Inverter LoadsOverload Conditions High Surge LoadsTrouble Loads Equipment DamageBattery Charging VoltageBattery Charging Flooded 14.4 13.5 Routine Maintenance Freedom HF UnitBatteries Inverter Overload Operation Invert Power Derating vs. Ambient Temperature Invert Power Derating vs. Ambient Temperature Troubleshooting Electrical Shock and Energy HazardCommon Problems Buzz in Audio EquipmentTelevision Reception Error Code Condition Mode Action  For error codes  to  Troubleshooting Reference Problem Possible Cause SolutionAC shore power is not available or out Inverter was probably damaged due to the reverse Problem Possible Cause Solution Inverter Applications Resistive LoadsMotor Loads Long Transfer TimesSpecifications Watt models 1800-watt modelsDC Input AC Input Page Page Schneider Electric Solar Inverters USA Inc
Related manuals
Manual 64 pages 12.33 Kb