Xantrex Technology 806-1054, 806-1840, 806-1544 Inverter was probably damaged due to the reverse

Freedom HF InvChg Owners Guide.book Page 40 Tuesday, April 29, 2014 12:10 PM

Troubleshooting Reference

Table 8 Troubleshooting Reference

Problem	Possible Cause	Solution
No output voltage. The Status LED is green	GFCI has tripped or 15A supplementary	Check load and reset the GFCI or supplementary breaker.
or yellow.	breaker has tripped.
	Circuit breaker on the AC load panel or	Reset the circuit breaker or check the AC output disconnect
	AC output disconnect has tripped.	circuits.
	Battery voltage is too low (depending	Check DC connections and cable.
	on setting, see “Operating Limits” on	Recharge battery.
	page 22) to start inverting. Display
	screen may show DC voltage as ..
No output voltage. The status LED is not	AC shore power is not available or out	• Check AC shore power.
lighting up.	of operating range and the inverter is	• Turn the inverter ON.
	OFF.
	AC shore power is not available and the	• Check AC shore power and battery voltage.
	inverter is OFF due to a shutdown for	• Turn the inverter ON and look at the display panel for any
	more than 30 seconds.	error code.
		• See Table 7, “Error Codes Displayed on the Display Panel
		Screen” on page 35.
	The inverter’s DC input polarity is	The inverter was probably damaged due to the reverse
	reversed.	polarity. This type of damage is NOT covered by the
		warranty.
		• Return the unit.
		• See Warranty Card for information on returning the unit.
40		Freedom HF Owner’s Guide