Hitachi C 8FSE, C 8FSHE specifications Packing

Page 28

PACKING

(1)How to install packings (A) and (B)

Remove the dust bag from the main body. Slide the head section toward the operator and insert packing (A) between the slide pipe, hinge and holder (A). Push the head back and secure the slide in position with packing (A) inserted by means of the slide securing knob.

Turn the turn table to the right 57° and remove the side handle. Place packing (B) under the head and push the head down. Insert the locking pin while pressing packing (B) to secure the head section in position (Fig. 35).

(2)How to install packings (C) and (D)

Put the main body mounted with packings (A) and (B) in the carton box aligning with the base packing and the inner frame (Fig. 36).

Put packing (C) in the left side of the carton box on the top of holder (A).

Put packing (D) in the right side of the carton box on the top of the switch handle.

Place the accessories in the space at the rear of the base (Fig. 37).

(3)How to install top packing (E)

Insert packing (E) in packings (C) and (D). Close the lids of the carton box and bind them together (Fig. 38).

Fig. 35	Packing (A)

Turn table

Packing (B)

Slide securing knob

Fig. 36

Inner frame

Base packing

Fig. 37

Packing (C)		Packing (D)
	Lid
Fig. 38		Packing (E)

Packing (C)

Packing (D)

-25-

Image 28

Contents Models C 8FSE, C 8FSHE Remark Contents Selling Point Descriptions Laser marker Only the Model C 8FSHEPositive angle stoppers Slide cutting Miter cutting Compound miter and bevel cutting Specifications Specifications· 216 mm 8-1/2 TCT saw blade 15.9 mm 5/8 bore, NT24 Comparisons with Similar Products Specification comparisonsFor Europe and others Except for the U.S.A and Canada C8FSE/C8FSHE For the U.S.A and Canada 8FB2 Right angleFull-load current a 9.2 a Precautions in Sales Promotion Safety instructionsPage Relative standards Laser marker only the Model C 8FSHEPrecautions concerning brake Ambient illuminance and visibility of laser lineConfirmation for use of sub fence Optional accessory Adjustment and Operational PrecautionsConfirmation of saw blade lower limit position Position adjustment of laser line Only the Model C 8FSHE How to use the vise assembly Adjustment of table insert positionCutting operation Page Bevel scale Clamp lever Tighten Crown molding stopper R Page Bevel angle adjustment Adjustment of ComponentsBall bushing Linear bearing Packing Repair Guide Precautions in disassembly and reassemblyTurn table and base assy Page Lower guard, link, spindle assy and dust guide Then remove the Lower Guard 215 from the Bearing HolderPage Armature assy and lock lever Page Laser marker Vise ass’yReassembly Special attentionWiring diagram Page Page Page Checking of insulation distance Reassembly requiring adjustmentNo-load current Lubrication Product precisionAdjustment of laser marker accuracy Page Page Troubleshooting guide 211Bushing 115 and slide Page 160 107 Standard Repair Time Unit Schedules 8FSHE8FSE Slide Compound SAW 8FSHE 501 Parts SUB Fence For USA, can Nylon Clip Ball Bearing 608VVC2PS2L Standard Accessories Model C 8FSE 8FSE 162 153 152 8FSE Scale a For USA, can Carbon Brush 1 Pair For GBR 110V, USA, CAN, VEN, TPE Lock Lever Spring Includ 626